Characterisation of space debris has become a fundamental task to facilitate sustainable space operations. Ground-based surveillance provides the means to extract key attributes from spacecraft. However, signal inversion attempts are generally under-constrained, which is why an increase in measurement channels through multispectral observations is expected to benefit parameter estimation. The current approach to simulating space debris observation at the Institute of Technical Physics of the German Aerospace Centre (DLR) in Stuttgart relies on monochromatic images taken from the POV-Ray render engine to form light curve signals. Rendered scenes are generated based on the location of an observer by propagating a target’s orbit and rotation. This paper describes the simulation of spectral light curves through the extension of DLR’s Raxus Prime simulation environment. Light reflections are computed using the Mitsuba2 spectral render engine, while atmospheric attenuation is accounted for by the radiative transfer library libRadTran. A validation of the simulator was achieved using multispectral measurements, carried out at the Uhlandshöhe research observatory in Stuttgart. Measured and synthetic data were found to be in agreement based on an RMS error <1% of the total measured signal count. Further, simulated spectral products were used to determine a target’s surface material composition and rotation state and examine aspects of laser ranging to non-cooperative targets.
Environmental pollution exists not only within our atmosphere but also in space. Space debris is a critical problem of modern and future space infrastructure. Congested orbits raise the question of spacecraft disposal. Therefore, state-of-the-art satellites come with a deorbit system in cases of low Earth orbit (LEO) and with thrusters for transferring into the graveyard orbit for geostationary and geosynchronous orbits. No practical solution is available for debris objects that stem from fragmentation events. The present study focuses on objects in LEO orbits with dimensions in the dangerous class of 1 to 10 cm. Our assumed method for the change of trajectories of space debris is laser ablation for collision avoidance or complete removal by ground-based laser systems. Thus, we executed an experimental feasibility study with focus on thermal and impulse coupling between laser and sample. Free-fall experiments with a 10 ns laser pulse at nominally 60 J and 1064 nm were conducted with GSI Darmstadt’s nhelix laser on various sample materials with different surfaces. Ablated mass, heating, and trajectory were recorded. Furthermore, we investigated the influence of the sample surface roughness on the laser-object interaction. We measured impulse coupling coefficients between 7 and 40 µNs/J and thermal coupling coefficients between 2% and 12.5% both depending on target fluence, surface roughness, and material. Ablated mass and changes in surface roughness were considered via simulation to discriminate their relevance for a multiple shot concept.
17 August 2021 in The Journal of the Astronautical Sciences
The aim of this paper is to verify if commonly occurring space debris materials change their reflectivity and morphology after being exposed to low energy protons. Therefore, a set of six different materials frequently used in spacecraft engineering was irradiated with low energy (100 keV) protons to simulate the aging of their surfaces due to space radiation in low Earth orbit (LEO). A microscopic and spectroscopic analysis of the irradiated samples reveals that the tested materials containing organic polymers (Polytetrafluoroethylene (PTFE) and carbon fiber reinforced plastic (CFRP)) show changes in surface morphology. Metallic surfaces did not show surface modifications but we found changes in the reflectivity of coated polyimide sheets, like used in Multi Layer Insulation blankets, during and after proton irradiation. Our results show that space materials exhibit significant changes after irradiation equivalent to the dose accumulated after 100 years in LEO. This knowledge is highly relevant for the interpretation of optical data related to the observation of space debris as well as to studies about laser-matter interaction for laser-based debris removal.
16 November 2023 in The Journal of the Astronautical Sciences
The radiation environment in Low Earth Orbit (LEO) is dominated by protons captured by Earth’s magnetic field in the Inner Van-Allen belt. Defunct satellites and other space debris objects can be resident in this environment for several decades and even centuries. So far, there is little knowledge about the impact of long-duration proton exposure to the surface morphology and reflectivity in LEO environment. We report on a laboratory test campaign exposing typical spacecraft materials with protons of 100 keV and 2.5 keV kinetic energy and a fluence corresponding to an in-orbit duration of 100 years and 120 years, respectively, in an 800 km sun-synchronous orbit. Although we find microscopic changes in surface morphology, reflectivity changes of all tested materials were smaller than 15%. This result brings positive news for on-going efforts to use optical methods, e.g. lightcurve measurements or active polarimetry, for characterizing space objects, since it suggests that data can - to a good approximation - be analyzed without accounting for proton induced aging effects that might affect the materials’ optical properties over time.