Although the effect of thermal modification (TM) on teak wood color is well documented, few studies have been carried out on closed-system processes, and it remains unclear what the effect is of different processes on the same material. This work aimed to verify the effect of closed- and open-system processes of TM on the color of short-rotation teak wood. Thermally modified wood (TMW) was evaluated in a closed system at 160 °C (CS160) and in an open system at 185 °C and 210 °C (OS185 and OS210). We measured the moisture content (initial and final) of the wood and the corrected mass loss (CML). The chemical analyses encompassed the contents of alpha-cellulose, hemicelluloses, lignin, and extractives (total, in acetone and dichloromethane). Wood color was measured before and after TM according to the CIEL*a*b* color space. It was possible to achieve the same color using different processes of thermal modification (CS160 and OS210). TM reduced wood lightness (L*), red–green chromaticity coordinate (a*), and yellow–blue chromaticity coordinate (b*). L* and a* had the biggest and smallest variations, respectively. TMW color was significantly changed, even at the mildest condition tested (OS185, 0.33% CML).
Introduction: Inventories are essential for forest management, but, in the Amazon region, the absence of standardization produces information loss, low accuracy, and inconsistent measurements. This prevents valid comparisons and compromises the use of information in networks and software. Sampling unit size is of key importance in the inventory of native forests, particularly regarding accuracy and costs. Objective: To identify a plot size that provides adequate precision for dendrometric parameters in the Amazon. Methods: In Cotriguaçu, Mato Grosso, Brazil, we tested four plot sizes with six repetitions each: 2 500, 5 000, 7 500, and 10 000 m². We measured diameter at breast height, population density, basal area, and biomass. We applied Shannon and Jaccard indexes; Weibull 2P and Gamma functions to fit the diametric distribution; and the Akaike Information Criterion for the best model. Results: There was a directly proportional relationship between plot area and population similarity, but diversity did not indicate significant alterations. Plot size did not affect dendrometric attributes and diametric distribution. Larger plot areas led to lower coefficients of variation and smaller confidence intervals. The Gamma function was the best model to represent the distributions of different plot sizes. Conclusions: For similar forests, we recommend the 2 500 m² plot to evaluate diameter at breast height, population density, basal area, and biomass.
Although the effect of thermal modification (TM) on teak wood color is well documented, a few studies were carried out in closed system processes, as well as it remains unclear the effect of different processes on the same material. This work aimed to verify the effect of closed and open system processes of TM on the color of fast-growing teak wood. Thermally modified wood was evaluated in a closed system at 160 °C (CS160) and in an open system at 185 °C and 210 °C (OS185 and OS210). We measured the moisture content (initial and final) of wood, and the corrected mass loss (CML). The chemical analyses encompassed the contents of alpha-cellulose, hemicelluloses, lignin, and extractives (total, in acetone and dichloromethane). Wood color was measured before and after TM according to the CIEL*a*b* color space. It was possible to achieve the same color using different processes of thermal modification (CS160 and OS210). TM reduced wood lightness (L*), red-green chromaticity coordinate (a*), and yellow-blue chromaticity coordinate (b*). L* and a* had the bigger and lower variations, respectively. The color of thermally modified wood was significantly changed, even at the mildest condition tested (OS185, 0.33% CML).
Visando a melhoria das práticas de manejo para a Tectona grandis L f., objetivou-se analisar as relações existentes entre as variáveis morfométricas da espécie. Os dados foram obtidos em um povoamento não manejado de Teca, implantado em 2002 na fazenda experimental da Universidade Federal de Mato Grosso, município de Santo Antônio do Leverger. Em campo foram mensurados os diâmetros à 1,3 m de altura (DAP) e na base da árvore à 0,10 m (DB); a altura total (HT) e comercial (HC). Para determinação da dimensão das copas foram medidos os raios de projeção no solo no sentido norte, sul, leste e oeste de 40 árvores amostras e distribuídas em 4 classes de diâmetro. A fim de descrever as relações morfométricas foram calculados os índices de abrangência, saliência e esbeltez para posterior serem obtidas a matriz de correlação de Pearson. Desta forma, as maiores correlações entre os índices morfométricos são para as variáveis de copa com o DAP podendo estas serem empregadas para dar suporte a tomadas de decisões ao manejo florestal como aplicação de desbastes
O estudo teve por objetivo avaliar sistema de equações utilizados na construção de diagramas de manejo de densidade. Os dados foram coletados em plantios clonais de teca na região centro-sul do estado de Mato Grosso. A idade de medição do plantio variou de um a oito anos, sendo que os dados foram coletados em parcelas circulares com área de 359 m2 a 616 m2. Das árvores que compuseram as unidades amostrais foram mensurados o diâmetro a altura do peito e a altura total. O volume foi calculado a partir da cubagem de 827 das árvores pelo método de Smalian. Dois sistemas de equações foram utilizados para a realização do estudo e a avaliação da precisão do ajuste foi realizada através das estatísticas: erro padrão residual (RMSE); erro padrão em escala percentual (RMSE%); coeficiente de determinação (R2) representado pelo coeficiente de correlação ao quadrado ( ); resíduos em escala percentual (Resíduo (%)); e análise gráfica do perfilhamento dos parâmetros. O sistema de equações que obteve melhor resultado foi o proposto por Dean e Baldwin, com valores de 0,9942 a 0,9994, e de 2,88 a1,84, em relação ao outro sistema que apresentou 0,9558 a 0,9539, e 13,94 a 7,99 para as estatísticas do R2 e RMSE (%), respectivamente. A distribuição dos resíduos do sistema de Dean e Baldwin foram também superiores, corroborando os resultados das análises estatísticas. Os resultados deste trabalho permitem inferir que o sistema de equações proposto por Dean e Baldwin é mais preciso, e, portanto, o indicado na elaboração de diagramas de manejo da densidade populacional em povoamentos clonais de teca.
Objetivou-se neste estudo modelar e avaliar as alterações temporais da distribuição diamétrica em povoamentos experimentais de teca (Tectona grandis L.f) com diferentes espaçamentos implantados na região de Cáceres-MT. As avaliações foram realizadas aos 11, 16 e 17 anos de idade, com a base de dados proveniente da medição do diâmetro a 1,3 m de altura (dap) nas parcelas. Para a modelagem diamétrica, adotou-se a função Weibull com três parâmetros e a qualidade dos ajustes foi avaliada através do teste de Kolmogorov-Smirnov. A função de Weibull com três parâmetros descreveu com precisão a distribuição diamétrica de teca em diferentes idades e espaçamentos. O aumento do espaçamento e da idade proporcionou um deslocamento modal para a direita em função do crescimento em dap das árvores. O ingresso de árvores nas sucessivas classes de diâmetro é menor em maiores densidades independentemente da idade, verifica-se que houve uma estagnação no crescimento nos diferentes tratamentos, com mais evidência para o mais adensado (3×2 m) indicando a necessidade de intervenção silvicultural por meio de desbastes. Palavras-chave: Tectona grandis; densidade de plantio; modelagem diamétrica; manejo florestal. TEMPORAL CHANGES IN THE DIAMETRIC DISTRIBUTION OF TEAK IN DIFFERENT SPACINGSABSTRACT: The objective of this study was to model and evaluate the temporal changes in the diametric distribution of experimental stands of teak (Tectona grandis L. f) in different spacings in the region of Cáceres-MT, Brazil. The evaluations were made at 11, 16 and 17 years of age, with the database coming from measurement of the diameter at 1.3m height (dbh) in the plots. For diametric modeling, we adopted the Weibull function with three parameters and the quality of the adjustments was by means of the Kolmogorov-Smirnov test. The Weibull function accurately described the diametric distribution of teak at different ages and spacings. The increase in spacing and age provide the modal shift to the right as a function of the growth in dbh of the trees. The entrance of trees in successive diameter classes is smaller in higher densities regardless of age, with more evidence for the denser one (3 × 2 m) indicating the need for silvicultural intervention through thinning. Keywords: Tectona grandis; planting density; diametric modeling; forest management.