Information concerning droplets impinging on airfoils, including their drag coefficient, that depends on the droplet shape is needed to feed computational codes used to simulate the ice accretion process on wing surfaces. A new model is presented to predict the droplet ratio of deformation for a given flowfield. This model is based on the analogy of a distorted droplet and a damped spring-mass system. It differs from known Taylor analogy breakup model, Clark’s model, and droplet deformation and breakup model in some departing assumptions. Comparisons of the model results with experimental data in the stagnation line show excellent agreement. The new model proposed here will aid to determine the drag coefficient evolution, being able to be included in ice accretion codes.
13 June 2011 in SAE International Journal of Advances and Current Practices in Mobility
This work presents the development of a Rotating Rig Facility by the Instituto Nacional de Técnica Aeroespacial (INTA) in cooperation with the NASA Glenn Research Center. The facility is located at the INTA installations near Madrid, Spain. It has been designed to study the deformation, breakup and impact of large droplets induced by aerodynamic bodies. The importance of these physical phenomena is related to the effects of Supercooled Large Droplets in icing clouds on the impinging efficiency of the droplets on the body that may change should these phenomena not be taken into account. The important variables and the similarity parameters that enter in this problem are presented. The facility's components are described and some possible setups are explained. Application examples from past experiments are presented in order to indicate the capabilities of the new facility.
1 September 2015 in Aerospace Science and Technology
Bubble drag reduction has been shown to be a promising technique for reducing the drag in ships, thus reducing the emission of pollutants and allowing the compliance with the new requirements imposed recently in this respect. Different searches have been conducted in the publications related to this technique, and an increase in interest has been shown, especially in the last decade. In this context, a review of the experimental work related to bubble drag reduction published in the last decade is presented in the present article. The works were classified according to the facility used (towing tank, cavitation tunnel, water channel, Taylor–Couette…), and the main finding are presented. It was found that two new trends in research have arisen, while there are still contradictions in the fundamental basis, which needs further study.