Bambang Sudarmanta

Dr. Bambang Sudarmanta


Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
13 July 2018 in AIP Conference Proceedings
Verified
Conference Paper
Closed access
PDF file
ASarif rahman saleh
arif rahman saleh
BSBambang Sudarmanta
Bambang Sudarmanta
Multi-stage gasification process adding multiple air injection (at pyrolysis and oxidation) to reduce tar content and improve the efficiency. all components of the fuel can decompose perfectly into pyrolysis products and the total pyrolysis product also increases. The mean temperatures in the pyrolysis zone are respectively between 569°C and 633°C for the 0% and 90% Air Ratios. Temperature increases in the pyrolysis zone change the nature of the endothermal into exothermal and providing the heat energy for the drying, oxidation and reduction zones. While the temperature of the partial oxidation zone reaches 858°C. For a total air flow of 10.5 Nm3/h with a 90% air ratio, the gasifier can produce a low tar content of 32.27 mg/Nm3 when compared to 0% air ratio of 106.5 mg/Nm3. This result shown that multi-stage gasifier can reduce tar content by 30%.

28 February 2022 in Energies
Verified
Journal Article
Open access
PDF file
JIJaka Isgiyarta
Jaka Isgiyarta
BSBambang Sudarmanta
Bambang Sudarmanta
JPJalu Aji Prakoso
Jalu Aji Prakoso
EJEka Nur Jannah
Eka Nur Jannah
ASarif rahman saleh
arif rahman saleh
The utilization of new and renewable energy sources explicitly based on biomass needs to be increased to reduce dependence on fossil fuels. One of the potential biomasses of plantation waste in Indonesia that can be utilized is oil palm plantation waste in the form of fronds and trunks that are converted with multi-stage downdraft gasification technology. This study aimed to conduct a technical analysis, economic analysis, investment risk analysis, social analysis, and an environmental impact assessment of power plants fueled by oil palm plantation waste. The method used was the upscaling of a prototype of a 10 kW power plant to 100 kW. The results showed that it was technically and economically feasible to apply. The economic indicators were a positive NPV of USD 48.846 with an IRR of 9.72% and a B/C ratio of 1.16. The risk analysis predicted a probability of an NPV 49.94% above the base case. The study of the social aspects suggested that the construction of power plants has a positive impact in the form of increased community income and the growth of new economic sectors that utilize electricity as a primary source. An analysis of the environmental effects is critical so that the impacts can be minimized. Overall, the construction of small-scale power plants in oil palm plantations is worth considering as long as it is carried out following the applicable regulations.

13 July 2018 in AIP Conference Proceedings
Verified
Conference Paper
Closed access
PDF file
BSBambang Sudarmanta
Bambang Sudarmanta
AGAbdul Gafur
Abdul Gafur
ASArif Rahman Saleh
Arif Rahman Saleh
BDBambang Arip Dwiyantoro
Bambang Arip Dwiyantoro
SASampurno
Sampurno
Biomass from palm oil plant waste in the form of palm fronds that are abundant but underutilized. Considering the large and consistent supply, oil palm fronds (OPF) could be a promising source of biomass energy through gasification. This Paper presents an experimental evaluation the quality of the producer gas in a two-stage gasifier, for different operating conditions. Varying the equivalent ratio (ER) to the gasifier and the distribution of gasification air between each gasification stages (ARpir-oks). The gas composition and its lower heating value (LHV) were also determined. Experimental tests were performed varying the operating conditions of the gasifier: the air flow between 17,3 kg/h, 23,1 kg/h, and 28,9 kg/h (the proximate equivalence ratio from 0,3, 0,4 and 0.5) and the air flow ratio in the two stages (ARpir-oks) between 0%, 70%, 80%, and 90%, evaluating the effects of these parameters over the quality of the gas. The results show that a highest CO content (22.1% v) was achieved for airflow 23.1 kg / s (ER 0.4) at AR 90% along with decreasing CH4 (0.97% v) while H2 (16, 27% v) highest achieved at AR 80%. LHV gas shows maximum value at 4542.5 Kj/kg achieved at Air Ratio (AR) 90% with air flow 23.1 kg / s (ER 0.4). Gasification of two-stageair supply increase gas composition and allowed to reduce the tar content in the producer gas. This result can be explained by increasing temperature in pyrolysis and combustion zone. Good stability and performance of pyrolysis and combustion zones, H2O and CO2 formed in this zone and their interaction with charcoal is excellent in endothermicwater-gas reaction and boudouard reaction.

1 July 2021 in International Journal of Sustainable Engineering
Verified
Journal Article
Closed access
BSBambang Sudarmanta
Bambang Sudarmanta
DYDori Yuvenda
Dori Yuvenda
AKAry Bachtiar K.P.
Ary Bachtiar K.P.
AWArif Wahjudi
Arif Wahjudi
ATAhmad Arbi Trihatmojo
Ahmad Arbi Trihatmojo
The availability of liquid fossil fuels is dwindling. Alternative fuels for CNG and CPO biodiesel that can be used in DF engines are the solution. However, the use of this fuel has reduced engine performance and increased CO and HC emissions. In addition, the use of CPO biodiesel as fuel for ignition in the DF engine is a parameter that has not been developed in previous studies so that it requires adjustment of engine parameter under standard conditions. Pilot injection timing (PIT) is critical in starting combustion in sequential combustion models of DF engine. This study aims to determine the effect of PIT using CPO biodiesel fuel on increasing engine performance and reducing emissions, so that this parameter becomes important. The PIT parameter was varied from 11° to 19° BTDC with 2° intervals at different engine loads on a DF engine. The results showed that CPO biodiesel is an effective pilot fuel in DF engine. PIT has a significant effect on increasing engine performance and reducing emissions. Increased thermal efficiency by 8.87% and HRR by 7.34%, while SFC emissions, CO emissions and HC emissions decreased by 43.85% and 25.33% respectively with a PIT of 15° BTDC at high load.

11 April 2021 in Automotive Experiences
Verified
Journal Article
Open access
PDF file
SMSigit Mujiarto
Sigit Mujiarto
BSBambang Sudarmanta
Bambang Sudarmanta
Hamzah FansuriHamzah Fansuri
Hamzah Fansuri
ASarif rahman saleh
arif rahman saleh
Municipal solid waste (MSW) is a type of general waste that includes households, traditional markets, commercial areas, and the rest from public facilities, schools, offices, roads, and so on. Refuse Derived Fuel (RDF) is obtained from the remnants of MSW which cannot be used anymore, which is flammable waste and is separated from parts that are difficult to burn through the process of chopping, sifting, and air classification. RDF has potential as an alternative energy source. In this study, RDF fuel was compared with MSW fuel both by proximate and calorific value, then the gasification process was carried out using a multi-stage downdraft gasifier to see gasification performance indicators such as syngas composition, LHV, cold gas efficiency, and tar concentration. The results showed that the gasification performance indicator for MSW biomass resulted in the syngas composition of CO = 19.08% v, H2 = 10.89% v, and CH4 = 1.54% v. The calorific value (Low Heating Value, LHV ) of syngas is 4,137 kJ/kg, cold gas efficiency is 70.14%, and tar content is 57.29 mg/Nm3. Meanwhile, RDF obtained the composition of CO gas: 18.68% v, H2: 9.5446% v, and CH4: 0% v. The maximum LHV syngas is 3365.08 kJ/kg, cold gas efficiency is 57.19 % and the smallest tar content is 80.24 mg/Nm3. When compared to RDF, MSW produces a better gasification performance indicator. However, RDF can still be used as an alternative energy source using the gasification process. The results of this study can be used to optimize the further RDF gasification process.

23 April 2022 in Automotive Experiences
Verified
Journal Article
Open access
PDF file
DYDori Yuvenda
Dori Yuvenda
BSBambang Sudarmanta
Bambang Sudarmanta
JJJamaludin Jamaludin
Jamaludin Jamaludin
OMOki Muraza
Oki Muraza
RPRandi Purnama Putra
Randi Purnama Putra
SPSri Rizki Putri Primandari
Sri Rizki Putri Primandari
Compressed natural gas (CNG) is a popular alternative fuel because of its more environmentally friendly properties than fossil fuels , including applications in diesel engines. However, supplying too much compressed natural gas fuel causes poor engine performance and emissions due to a decrease in the air-fuel ratio on the dual-fuel engine. The addition of air using electric superchargers was done to return the air-fuel ratio to ideal conditions. Lambda value (λ) was variation under low load (1.52 to 2.71), medium load (1.18 to 2.17), and high load (0.94 to 2.17) on a CNG-diesel dual fuel engine. The addition of pure air in each load can increase combustion stability in certain lambda, which was indicated by an increase in thermal efficiency, heat release rate, and a decrease in ignition delay, combustion duration, hydrocarbon, and carbon monoxide emissions.