Xingchao TIAN

Dr. Xingchao TIAN


Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
11 March 2022 in Lithosphere
Verified
Journal Article
Open access
PDF file
XTXingchao TIAN
Xingchao TIAN
TTTiejun Tao
Tiejun Tao
QLQianxing Lou
Qianxing Lou
CXCaijin Xie
Caijin Xie
When the Holmquist-Johnson-Cook (HJC) constitutive model is used to simulate limestone under the impact load, problems of a compaction stage not being characterised and low dynamic peak stress prediction accuracy are observed. The numerical simulation and experimental results were inconsistent. In this study, we proposed a modified HJC constitutive model and parameter determination method. Based on the characteristics of the dynamic stress-strain curve of limestone and relationship between axial and volumetric strains, the linear elastic phase of the state equation of the original HJC constitutive model was modified, and a new state equation was proposed. The yield surface of the original HJC constitutive model was modified on the basis of the sensitivity analysis method and limit surface theory, and a method for determining the parameters of the modified HJC constitutive model of limestone was proposed. The modified model and parameter determination method were experimentally verified using the split Hopkinson pressure bar (SHPB) and a high-speed camera. The results showed that the state equation curve of limestone under the impact load was divided into compaction, linear elastic, and fully compacted stages. After the introduction of the pressure parameters M⁠, P⁠, and Q⁠, the nonlinear change in the stress-strain curve during the compaction stage was highly consistent with the SHPB results. The strength parameters fc⁠, A⁠, B⁠, and N exhibited the maximum impact on the dynamic strength of limestone. After the strength parameters A⁠, B⁠, and N were modified for the yield surface, the prediction accuracy of limestone dynamic peak stress was over 97%, the prediction error rate decreased by more than 10%, and the reliability of numerical simulation results improved. These results can provide a simple and feasible numerical simulation method for the dynamic analysis of rock materials.

25 October 2022 in Geofluids
Verified
Journal Article
Open access
PDF file
XTXingchao TIAN
Xingchao TIAN
TTTiejun Tao
Tiejun Tao
CXCaijin Xie
Caijin Xie
To explore the dynamic mechanical properties and damage evolution law of the more common layered rock masses in geotechnical engineering, this paper determined the Holmquist–Johnson–Cook (HJC) constitutive model parameters of dolomite, gray sandstone, and limestone according to the static mechanical parameters of the rock mass. We used Hypermesh/ANSYS software to establish the numerical analysis model, carried out the dynamic impact numerical simulation of the layered rock mass, and analyzed the stress wave propagation characteristics, dynamic stress–strain relationship, energy dissipation, and damage evolution laws of layered rock masses under different combinations. At the same time, this paper analyzed the stress characteristics of the layered rock mass and studied its failure characteristics. The research results show that the wave impedance matching relationship alters the dynamic characteristics of the layered rock mass; however, with the increase in impact velocity, the difference gradually weakens. The difference in elastic modulus leads to different initial failure modes of layered rock masses, and the quality of the wave impedance matching relationship leads to differences in the law of damage evolution of layered rock masses. Under different combination forms, the failure degree and failure modes of the two parts of the layered rock mass are different.


19 February 2026 in Ceramics
Verified
Journal Article
Open access
PDF file
YWYuying Wang
Yuying Wang
CLChaoyang Liu
Chaoyang Liu
TYTan Yanping
Tan Yanping
SZSongsong Zhang
Songsong Zhang
TZTing Zhu
Ting Zhu
XTXingchao TIAN
Xingchao TIAN
To synergistically integrate piezoelectric and varistor functionalities in a single material, PNN-PZT piezoelectric powder (abbreviated as P) and ZnO-based varistor powder (abbreviated as Z) were utilized to fabricate PZT-ZnO composite ceramics (denoted as PZm) via conventional solid-state sintering. The P/Z molar ratio was regulated to 1/0.9, 1/1.05, 1/1.2, 1/1.35, and 1/1.5 to systematically study its influence on the phase composition, microstructure, and electrical properties of the composites. XRD, SEM, EDS characterization, and electrical performance tests were carried out. Results indicate that all PZm samples exhibit the biphasic coexistence of perovskite (piezoelectric phase) and wurtzite (varistor phase) without impurity phases, consisting of large perovskite grains with distinct edges and small wurtzite grains with smooth surfaces. The PZ3 sample (P/Z = 1/1.2) achieves optimal comprehensive properties: d33 = 161 pC/N, kp = 0.25, Ɛr = 2527, tan δ = 3.83%, E1mA = 1396 V/mm, IL = 8.2 mA, α = 22.06. This work confirms the synergistic optimization of piezoelectric and varistor properties in PZT-ZnO composites, providing a reliable experimental basis for the formulation design and performance regulation of multifunctional ceramics.

9 February 2026 in Fatigue & Fracture of Engineering Materials & Structures
Verified
Journal Article
Closed access
YQYousheng Qian
Yousheng Qian
TTTiejun Tao
Tiejun Tao
LLLiansheng Liu
Liansheng Liu
XTXingchao TIAN
Xingchao TIAN
SSShuai Song
Shuai Song

23 June 2026 in Sustainability
Verified
Journal Article
Open access
PDF file
XYXiaoai Yin
Xiaoai Yin
YTYuan Tian
Yuan Tian
ZLZhennan Liu
Zhennan Liu
XTXingchao TIAN
Xingchao TIAN
YLYi Liang
Yi Liang
YLYuanzhou Liu
Yuanzhou Liu
Abandoned slopes often encounter problems such as compacted soil and lack of nutrients. Biochar, as a promising soil amendment agent, can effectively enhance soil fertility. Moreover, evaluating the nutrient and microbial characteristics during the improvement process is of great significance for revealing its mechanism of action in improving abandoned land. This study analyzed the characteristics of soil nutrients, microbial community structure, and co-occurrence network after reclamation under different application rates (0%, 1%, 2.5%, 4%, 5.5%, hereinafter referred to as CK, T1, T2, T3, T4) of corn straw biochar. The results showed that biochar significantly increased soil organic carbon (by 60.74–164.82%), total nitrogen (11.31–27.73%), and total phosphorus (13.32–56.03%) content, and the effect was best at a rate of 4% (T3). With the increase in biochar application rate, soil bulk density generally showed a downward trend, and pH generally showed an upward trend. Significant levels (p < 0.05) were reached from T2 to T4. There was a strong linear correlation between biochar application rate and soil organic matter, total nitrogen, and pH in the fitted model, with R2 values reaching 0.753, 0.601, and 0.706, respectively. Microbial community analysis showed that biochar application changed the bacterial community structure. With the increase in soil depth, the Shannon index and Chao index of each treatment generally increased, indicating that soil depth is one of the key factors regulating the community structure. Biochar application promoted the proliferation of beneficial bacterial groups such as Pseudomonadota and Acidobacteriota, by increasing the number of co-occurrence network nodes and edges enhancing the complexity and stability of the microbial network.