An inductive power transfer subsystem for an integrated motor drive is presented in this paper. First, the concept of an integrated motor drive system is overviewed, and its main components are described. Next, the paper is focused on its inductive power transfer subsystem, which includes a magnetically coupled resonant circuit and two-stage energy conversion with an appropriate control method. Simplified complex domain analysis of the magnetically coupled resonant circuit is provided and the applied procedure for its component selection is explained. Furthermore, the prototype of the integrated motor drive system with its control is described. Finally, the prototype based on the gallium nitride field effect transistors (GaN FET) inductive power transfer subsystem is experimentally tested, confirming the feasibility of the concept.

This article deals with the design, development, and analysis of a wireless power transfer system prototype based on capacitive coupling. The system is intended for the continuous charging of a suspended mine drivetrain. It consists of a resonant inverter, primary and secondary matching circuits, a suitable capacitive coupler, and a rectifier with a load, ultimately serving as a battery charger for a mobile energy storage device. The system successfully achieved the target output voltage of 320 V and a charger output power of 2 kW at an operating frequency of 300 kHz. Additionally, the total system efficiency was at the level of 60%, ensuring that the RMS voltages on passive components remained below 3 kV.

This paper presents new resonant inverter topologies for dual-frequency induction heating (IH). These 2T1C and 3T topologies combine the advantageous features of two- and one-inverter solutions. An analytical description of the load impedance of a dual-frequency series-parallel circuit has been made. Using manufacturer datasheets and LTspice models of selected transistors, a MATLAB model was parameterized. Based on it, power losses are determined as a function of the following parameters: nominal power, frequency and DC bus voltage. The obtained results allowed for determining the data necessary in the design process. The research has been experimentally verified. Tests were carried out for pulsing and simultaneous operation. Power control characteristics as a function of frequency are determined. The possibility of operating the inverter with high efficiency (>97%) in the proposed 2T1C and 3T systems at nominal power is demonstrated.

Interleaved zero-voltage switching boost converters have been known for over 20 years. However, the influence of parasitic capacitance of transistors has not been described. In this paper the converter is analyzed and the equation for voltage ratio is derived for any number of converter phases. First a general description of the topology, including main voltage and current waveforms, is provided. Subsequently the converter is analyzed and conditions for soft switching are derived. Next the analysis results are compared to measurements of an experimental converter setup. Discrepancies are identified and the influence of parasitic capacitance is analyzed. By considering the parasitic capacitance the difference between experimental and analytical results of voltage ratio is reduced from 0.2 to less than 0.05.

The paper shows the construction and operation of the High-Voltage High-Frequency Coaxial Cable Energy Transfer System dedicated to a three-phase 500 V mining grid with an ungrounded neutral point. The correct operation of the model was verified through simulation and experiments. This paper focuses on the overall system efficiency and the power loss analysis of its components. Based on these measurements, it is concluded that the presented system is suitable for mining applications, where high energy conversion efficiency is essential due to the difficulty of dissipating heat to the environment.