This research investigates the enhanced photocatalytic activity of cuprous oxide (Cu₂O) nanoparticles (NPs)-titanium dioxide (TiO₂) nanotube (NT) composites for air purification, focusing on the removal of volatile organic compounds (VOCs) and Escherichia coli (E. coli) bacteria under simulated sunny light. Cu₂O-NPs were successfully deposited onto TiO₂-NTs via the successive ionic layer adsorption and reaction method. The resulting p- and n-type semiconductor heterojunction nanocomposites were characterized using various techniques, including scanning electron microscopy, transmission electron microscopy, ultraviolet–visible-light spectroscopy, and chlorinated radicals. The photocatalytic activity was evaluated for different VOCs present in indoor air (butadione, chloroform, and butyraldehyde) in the presence of E. coli bacteria. The results showed that the Cu₂O-NPs/TiO₂-NTs composites exhibited enhanced photocatalytic activity compared to pure TiO₂-NTs. The Langmuir–Hinshelwood model was used to describe the degradation kinetics, revealing that Cu₂O loading and the nature of the target pollutant influence the photocatalytic efficiency. This study has also highlighted the role of chlorinated radicals in the degradation process, especially for chloroform. The degradation process of chloroform generated chlorine radicals, which not only contributed to the degradation of other VOCs, but also enhanced the overall oxidative capacity of the system. This synergistic effect was observed to accelerate pollutant removal and improve the antibacterial efficacy against E. coli. The Cu₂O-NPs/TiO₂-NTs composites demonstrated significant reusability and antibacterial properties, highlighting their potential for sustainable indoor air purification applications.

This study investigated the remediation of organic acid pollutants, specifically butyric acid (C₄H₈O) and valeric acid (C₅H₁₀O₂), as well as their binary mixtures in the vapor phase at various ratios. The remediation process involved the use of a continuous pilot-scale reactor. A TiO₂ catalyst was deposited on glass fiber tissue (GFT) and ultraviolet (UV) irradiation with an intensity of 20 W/m². The main objective of this study was to assess the effectiveness of the photocatalytic process by oxidizing and mineralizing a mixture of carboxylic acids in a rectangular reactor at pilot scale. This was achieved by calculating the removal efficiency and the selectivity of CO₂ (S_CO2). Each individual compound was treated separately, followed by the treatment of binary mixtures with molar fractions of 0.25, 0.5, and 0.75. The concentration of pollutants at the inlet varied between 50, 100, 150, and 200 mg/m³, while the flowrate ranged from 2 to 6 m³/h. The obtained results for the removal efficiency of butyric acid, the binary acid mixture (25% butyric acid + 75% valeric acid), and valeric acid were satisfactory, with percentages of 58%, 32%, and 41%, respectively. It is evident that the selectivity toward CO₂ is better for butyric acid compared to valeric acid and the binary carboxylic acid mixture, with values of 43.70%, 33.49%, and 21.96%, respectively, across all concentrations. A simulation model based on mass transfer and catalytic oxidation mechanisms was developed and successfully validated against the experimental data for each pollutant. Reusability tests conducted on the TiO₂ on GFT, both in its initial (clean) state and after 50 h of the photocatalytic treatment of butyric acid, showed a 15% decrease in photocatalytic efficiency.