This article reports an original concept enabling the rapid fabrication of continuous-flow microfluidic chips with a programmable and reconfigurable geometry. The concept is based on a digital microfluidic platform featuring an array of individually addressable electrodes. A selection of electrodes is switched on sequentially to create a de-ionized (DI) water finger specific pattern, while the surrounding medium consists of liquid-phase paraffin. The water displacement is induced by both electrowetting on dielectric and liquid dielectrophoresis phenomena. Once the targeted DI water pattern is obtained, the chip temperature is lowered by turning on an integrated thermoelectric cooler, forming channel structures made of solidified paraffin with edges delimitated by the DI water pattern. As a result, the chip can be used afterwards to conduct in-flow continuous microfluidic experiments. This process is resettable and reversible by heating up the chip to melt the paraffin and reconfigure the microchannel design on demand, offering the advantages of cost, adaptability, and robustness. This paper reports experimental results describing the overall concept, which is illustrated with typical and basic fluidic geometries.

Surface phonon-polaritons (SPhPs) are evanescent electromagnetic waves that can propagate distances orders of magnitude longer than the typical mean free paths of phonons and electrons. Therefore, they are expected to be powerful heat carriers capable of significantly enhancing the in-plane thermal conductance of polar nanostructures. In this work, we show that a SiO₂/Si (10 $\mathsf{\mu }$m thick)/SiO₂ layered structure efficiently enhances the SPhP heat transport, such that its in-plane thermal conductance is ten times higher than the corresponding one of a single SiO₂ film, due to the coupling of SPhPs propagating along both of its polar SiO₂${}_{\mathrm{}}$ nanolayers. The obtained results thus show that the proposed three-layer structure can outperform the in-plane thermal performance of a single suspended film while improving significantly its mechanical stability.

This study presents a new application of Liquid DiElectroPhoresis (LDEP) for local surface functionalization of a planar substrate. Circular spots (diameter ranging from 24 to 100 μm) made of PolyEthyleneImine (PEI) polymer can be accurately positioned, after evaporation of sessile microdroplets, created by LDEP, from a solute polymer. This local surface modification is validated by trapping of Bacillus subtilis spores onto these spots.

We develop an ultra-high-temperature vacuum probe station (UHT-VPS) featuring a sample holder heated by thermal radiation from a silicon carbide heater. This contactless configuration electrically isolates the sample from the high-power heating source through a vacuum gap, ensuring reliable measurements under extreme conditions. The capability of this UHT-VPS to measure electrical signals from 30 nV upward on bulk sapphire is demonstrated using the 3w/2w method. Measurements are continuously operated from 300 to 1150 K, under high vacuum, for a total of about 66 hours without readjusting the contact. They yield the linear and quadratic temperature coefficients of resistance of chromium/platinum micro-resistances, as well as the sapphire's thermal conductivity and thermal diffusivity. By recording the heater and sensor temperature signals up to 30 kHz and fitting them with theoretical models that account for the quadratic TCR of Cr/Pt microwires, we obtain values in agreement with literature data obtained by optical methods. In this temperature range, we also measure thermal conductivity, which cannot be directly accessed by optical techniques. Our system thus provides an effective solution for simultaneously retrieving the electrical and thermal properties of materials using a single set of 3w/2w data up to unprecedented temperature levels.