The joining of porous Si₃N₄ to dense Si₃N₄ ceramics has been successfully performed using mixed RE₂O₃ (RE = Y or Yb), Al₂O₃, SiO₂, and α-Si₃N₄ powders. The results suggested that the α-Si₃N₄ powders partly transformed into β-SiAlON and partly dissolved into oxide glass to form oxynitride glass. Thus, composites of glass/β-SiAlON-ceramic formed in the seam of joints. Due to the capillary action of the porous Si₃N₄ ceramic, the molten glass solder infiltrated into the porous Si₃N₄ ceramic side during the joining process and formed the “infiltration zone” with a thickness of about 400 μm, which contributed to the heterogeneous distribution of the RE–Si–Al–O–N glasses in the porous Si₃N₄ substrate. In-situ formation of β-SiAlON in the seam resulted in a high bonding strength. The maximum bending strength of 103 MPa and 88 MPa was reached for the porous Si₃N₄/dense Si₃N₄ joints using Y–Si–Al–O–N and Yb–Si–Al–O–N glass solders, respectively.

HfNbTaTiZr high-entropy alloy has wide application prospects as a biomedical material, and the use of laser additive manufacturing can solve the forming problems faced by the alloy. In view of the characteristics of the one-time forming of additive manufacturing methods, it is necessary to develop non-mechanical processing modification methods. In this paper, deep cryogenic treatment (DCT) is first applied to the modification of a HEA with BCC structure, then the post-processing method of DCT is combined with laser melting deposition (LMD) technology to successfully realize the coordinated improvement of forming and strength–ductility synergistic improvement in lightweight Hf_0.25NbTa_0.25TiZr alloy. The final tensile strength of the alloy after DCT treatment is 25% higher than that of the as-cast alloy and 11% higher than that of the as-deposited alloy, and the elongation is increased by 48% and 10%, respectively. In addition, DCT also achieves induced phase transition without additional deformation.