This paper proposes a synthesis of different electrical methods used to estimate the temperature of power semiconductor devices. The following measurement methods are introduced: the voltage under low current levels, the threshold voltage, the voltage under high current levels, the gate-emitter voltage, the saturation current, and the switching times. All these methods are then compared in terms of sensitivity, linearity, accuracy, genericity, calibration needs, and possibility of characterizing the thermal impedance or the temperature during the operation of the converter. The measurement of thermo-sensitive parameters of wide bandgap semiconductors is also discussed.
16 September 2014 in IEEE Industrial Electronics Magazine
Power electronic systems play an increasingly important role in providing high-efficiency power conversion for adjustable-speed drives, power-quality correction, renewable-energy systems, energy-storage systems, and electric vehicles. However, they are often presented with demanding operating environments that challenge the reliability aspects of power electronic techniques. For example, increasingly thermally stressful environments are seen in applications such as electric vehicles, where ambient temperatures under the hood exceed 150 °C, while some wind turbine applications can place large temperature cycling conditions on the system. On the other hand, safety requirements in the aerospace and automotive industries place rigorous demands on reliability.
1 April 2013 in IEEE Transactions on Industry Applications
The measurement of the junction temperature with thermosensitive electrical parameters (TSEPs) is largely used by electrical engineers or researchers, but the obtained temperature value is generally not verified by any referential information of the actual chip temperature distribution. In this paper, we propose to use infrared (IR) measurements in order to evaluate the relevance of three commonly used TSEPs with insulated gate bipolar transistor chips: the saturation voltage under a low current, the gate-emitter voltage, and the saturation current. TheIR measurements are presented in detail with an estimation of the emissivity of the black paint deposited on the power module. The temperatures obtained with IR measurements and with the different TSEPs are then compared in two cases: the use of only one chip and the use of two paralleled chips.
Power conversion systems are dependent on the performance and reliability of static converters. However, they are subject to frequent functional and environmental strains, which can induce failures. The anticipation of these failures is difficult but important so the operation of a system can be halted before a breakdown occurs. In the case of photovoltaic (PV) power plants, the system can be simplified into two distinct blocks: the solar panels/modules and the power inverter. A breakdown in either of these blocks can cause significant downtime in the system. Nevertheless, multiple solar module failures can often be tolerated and not lead to a total breakdown of the entire array, whereas a single component failure in the inverter can lead to a collapse of the entire system. Furthermore, solar panel/module manufacturers often offer warranties of up to 20 years, while warranties for inverters rarely reach the ten-year mark [1]. As such, the overall cost of a PV inverter can increase by a factor of two or three if it undergoes one or two failures during the life of the system. Although the market competition between PV inverter manufacturers has traditionally focused on the efficiency of their product, a failure that induces a downtime of just a few days can easily negate the yield attained through a 1% efficiency improvement. Oversizing the inverter or introducing redundancy into the inverter system is one option to improve reliability; however, often, this is not economical.
27 May 2016 in IEEE Transactions on Power Electronics
Infrared measurements are used to assess the measurement accuracy of the peak gate current (IGPeak) method for Insulated-gate bipolar transistor (IGBT)junction temperature measurement. Single IGBT chips with the gate pad in both the center and the edge are investigated, along with paralleled chips, as well as chips suffering partial bondwire lift-off. Results are also compared with a traditional electrical temperature measurement method: the voltage drop under low current (VCE (low )). In all cases, the IGPeak method is found to provide a temperature slightly overestimating the temperature of the gate pad. Consequently, both the gate pad position and chip temperature distribution influence whether the measurement is representative of the mean junction temperature. These results remain consistent after chips are degraded through bondwire lift-off. In a paralleled IGBT configuration with nonnegligible temperature disequilibrium between chips, the IGPeak method delivers a measurement based on the average temperature of the gate pads.