The increase in waterproof surfaces, a typical phenomenon of urbanization, on the one hand, reduces the volume of rainwater that naturally infiltrates the subsoil and, on the other, it determines the increase in speeds, flow rates, and outflow volume surface; at the same time, it causes a qualitative deterioration of the water. This study researched the optimal management of urban drainage systems via the combined application of real-time control and green technologies. A hydraulic model of the sewer system of the suburbs of Bologna (Italy) was set up using the Environmental Protection Agency (EPA) Storm Water Management Model (SWMM) to evaluate the reduction in water volume and the masses of pollutants discharged in water bodies. The combined application of these technologies allows significantly reducing both the pollutants released into the receiving water bodies and the overflow volumes, while optimizing the operation of the treatment plants. Green technologies cause an average reduction equal to 45% in volume and 53% of total suspended solids (TSS) sent to the receiver. The modeled cases represent only some of the possible configurations achievable on urban drainage systems; the combined use of different solutions could lead to further improvements in the overall functioning of the drainage system.

This study proposes the results of a research activity devoted to the analysis and development of methodologies, models and strategies, which allow integrating decentralized solutions such as rainwater harvesting, greywater reuse systems, and green technologies in buildings. A methodology based on a hydraulic/hydrological model developed by means of SWMM is presented. It allows estimating the optimal size of the storage tanks, considering the overall efficiency of the system, and calculating the wastewater overflows reduction. This study is carried out within the Work Package three (WP3) of the GST4Water project funded by the Emilia-Romagna Regional Council (Italy) through the European Regional Development Fund 2014–2020 ERDF—ROP.

Climate change and an increase in urbanization are severely testing urban drainage systems; at the same time, population growth is leading to an increase in demand for water resources, while climate change is more likely to reduce the amount of water that is available to meet this demand. The present study finds a solution to both problems by assuming a hybrid use of detention basins, i.e., providing a real-time control system (RTC) for the outfall discharge managed according to the rainfall forecast and the water level in the tank, to reuse rainwater for non-potable use and, at the same time, to guarantee the hydraulic protection of the downstream system. Twenty-seven scenarios were simulated using the numerical model SWMM 5.1, assuming different types of controls on the discharge. The simulations show a non-potable water-saving efficiency from a minimum of 32% to a maximum of 90%, and the reduction in volume discharged is between 11% and 31%, while the peak flow rate varies more significantly depending on the type of control used. These results highlight the detention basins’ potential deriving from the hybrid use of this system with rainwater harvesting systems.

A global shift towards renewable energy production, driven primarily by the challenges posed by climate change, is currently underway. In this context, the utilization of heat recovery from municipal wastewater emerges as a promising green technology. Notably, the advantage of implementing energy recovery in sewers, as opposed to wastewater treatment plants (WWTPs), lies in the higher temperature of the wastewater and its proximity to potential heat users. Despite these benefits, concerns arise regarding the potential adverse effects on biological wastewater treatment processes downstream of the heat recovery section, particularly during colder seasons. This paper seeks to assess the impact of a heat recovery system along the sewer network on the efficiency of biological wastewater treatment processes. The methodology involves a modeling analysis of a real sewage network in Italy. Under typical northern Italy climate conditions, the results demonstrate the feasibility of heat recovery in sewers for WWTPs designed with a sludge residence time under aerobic conditions (SRT_aer) greater than 13 days. In such cases, the nitrification process remains relatively unaffected. However, for lower SRT_aer values, a case-specific feasibility assessment is recommended to evaluate the overall process efficiency comprehensively.