This study compared the yield of biodiesel produced from tall oil fatty acids (TOFA) via (i) homogeneous catalyst (sulfuric acid) and (ii) a heterogeneous catalyst (Amberlyst® BD20, together with Ambersep BD 19 (Midcontinental Chemical Co., Olathe, KS, USA)® using a batch reactor. The effect of operation conditions including temperature, catalyst concentration, methanol: oil ratio and reaction time on esterification yield were investigated. Gas chromatographic data showed that the major fatty acids present in the TOFA are oleic acid (C18:1n9) and linoleic acid (C18:2n6). Homogenous catalysis yielded 96.76% biodiesel compared to 90.24% for heterogeneous catalysis. Optimized conditions for homogenous catalysis were at a catalyst concentration of 0.5 w/w%, 15:1 methanol: oil mass ratio at 55 °C for 60 min. FTIR results also showed that the homogeneous catalyst yielded a more complete reaction toward biodiesel production in a shorter time (60 min) compared to the heterogeneous catalyst (4.7 h). For heterogeneous catalysis, the highest yield and the lowest acid value were achieved after a second recycling because the reactants were not fully in contact with the catalyst during the first recycling. The catalyst did not show a reduction in catalytic activity even after the fourth recycling. However, the acid value was higher than that for ASTM standards for biodiesel.
We report for the first time the evaluation of oils from the tropical forest tree, Allanblackia, shea butter and palm kernel oil as a potential phase change material for thermal energy storage based upon its thermo-physical and chemical properties. Differential Scanning Calorimetry showed that all the oils were polymorphic and hence exhibited multiple melting/freezing profile over a wide range. For both melting and freezing cycles, Allanblackia oil showed high latent heat of energy (80.53 J/g) with the highest melting point profile (34.74 °C) of all the oils. Thermo-gravimetric analysis showed that all the oil samples were thermally stable and did not degrade within the temperature of interest even though Allanblackia oil showed an increase in weight around 37 °C indicating oxidative instability. Chemical stability was confirmed by FTIR spectra. Of all the oils studied, Allanblackia exhibited a potential for use as a PCM for thermal energy storage if purified to improve oxidative stability.