Stochastic logic performs computation on data represented by random bit-streams. The representation allows complex arithmetic to be performed with very simple logic, but it suffers from high latency and poor precision. Furthermore, the results are always somewhat inaccurate due to random fluctuations. In this paper, we show that randomness is not a requirement for this computational paradigm. If properly structured, the same arithmetical constructs can operate on deterministic bit-streams, with the data represented uniformly by the fraction of 1's versus 0's. This paper presents three approaches for the computation: relatively prime stream lengths, rotation, and clock division. Unlike stochastic methods, all three of our deterministic methods produce completely accurate results. The cost of generating the deterministic streams is a small fraction of the cost of generating streams from random/pseudorandom sources. Most importantly, the latency is reduced by a factor of (1/2 ⁿ ), where n is the equivalent number of bits of precision. When computing in unary, the bit-stream length increases with each level of logic. This is an inevitable consequence of the representation, but it can result in unmanageable bit-stream lengths. We discuss two methods for maintaining constant bit-streams lengths via approximations, based on low-discrepancy sequences. These methods provide the best accuracy and area × delay product. They are fast-converging and therefore offer progressive precision.

Sorting is a common task in a wide range of applications from signal and image processing to switching systems. For applications that require high performance, sorting is often performed in hardware with application-specified integrated circuits or field-programmable gate arrays. Hardware cost and power consumption are the dominant concerns. The usual approach is to wire up a network of compare-and-swap units in a configuration called the Batcher (or bitonic) network. Such networks can readily be pipelined. This paper proposes a novel area-efficient and power-efficient approach to sorting networks, based on ``unary processing.'' In unary processing, numbers are encoded uniformly by a sequence of one value (say 1) followed by a sequence of the other value (say 0) in a stream of 0's and 1's with the value defined by the fraction of 1's in the stream. Synthesis results of complete sorting networks show up to 92% area and power saving compared to the conventional binary implementations. However, the latency increases. To mitigate the increased latency, this paper uses a novel time-encoding of data. The approach is validated with two implementations of an important application of sorting: median filtering. The result is a low cost, energy-efficient implementation of median filtering with only a slight accuracy loss, compared to conventional implementations.

Binarization plays an important role in document image processing, particularly in degraded document images. Among all local image thresholding algorithms, Sauvola has excellent binarization performance for degraded document images. However, this algorithm is computationally intensive and sensitive to the noises from the internal computational circuits. In this paper, we present a stochastic implementation of Sauvola algorithm. Our experimental results show that the stochastic implementation of Sauvola needs much less time and area and can tolerate more faults, while consuming less power in comparison with its conventional implementation.

Stochastic computing (SC) is a promising technique for applications that require low area overhead and fault tolerance, but can tolerate relatively high latency. In the SC paradigm, logical computation is performed on randomized bit streams. In prior work, streams were generated with linear feedback shift registers; these contributed heavily to the hardware cost and consumed a significant amount of power. This paper introduces a new approach for encoding signal values: computation is performed on analog periodic pulse signals. Exploiting pulse width modulation, time-encoded signals corresponding to specific values are generated by adjusting the frequency and duty cycles of pulse width modulated (PWM) signals. With this approach, the latency, area, and energy consumption are all greatly reduced. Experimental results on image processing applications show up to 99% performance speedup, 98% saving in energy dissipation, and 40% area reduction compared to prior stochastic approaches. Circuits synthesized with the proposed approach can work as fast and energy-efficiently as a conventional binary design while retaining the fault-tolerance and low-cost advantages of conventional stochastic designs.

Artificial neural networks are powerful computational systems with interconnected neurons. Generally, these networks have a very large number of computation nodes which forces the designer to use software-based implementations. However, the software based implementations are offline and not suitable for portable or real-time applications. Experiments show that compared with the software based implementations, FPGA-based systems can greatly speed up the computation time, making them suitable for real-time situations and portable applications. However, the FPGA implementation of neural networks with a large number of nodes is still a challenging task. In this paper, we exploit stochastic bit streams in the Restricted Boltzmann Machine (RBM) to implement the classification of the RBM handwritten digit recognition application completely on an FPGA. We use finite state machine-based (FSM) stochastic circuits to implement the required sigmoid function and use the novel stochastic computing approach to perform all large matrix multiplications. Experimental results show that the proposed stochastic architecture has much more potential for tolerating faults while requiring much less hardware compared to the currently un-implementable deterministic binary approach when the RBM consists of a large number of neurons. Exploiting the features of stochastic circuits, our implementation achieves much better performance than a software-based approach.

Computations based on stochastic bit streams have several advantages compared to deterministic binary radix computations, including low power consumption, low hardware cost, high fault tolerance, and skew tolerance. To take advantage of this computing technique, previous work proposed a combinational logic-based reconfigurable architecture to perform complex arithmetic operations on stochastic streams of bits. The long execution time and the cost of converting between binary and stochastic representations, however, make the stochastic architectures less energy efficient than the deterministic binary implementations. This article introduces a methodology for synthesizing a given target function stochastically using finite-state machines (FSMs), and enhances and extends the reconfigurable architecture using sequential logic. Compared to the previous approach, the proposed reconfigurable architecture can save hardware area and energy consumption by up to 30% and 40%, respectively, while achieving a higher processing speed. Both stochastic reconfigurable architectures are much more tolerant of soft errors (bit flips) than the deterministic binary radix implementations, and their fault tolerance scales gracefully to very large numbers of errors.