Within the double-sided countersunk riveting process of aircraft wings with a composite wedge structure, riveting consistency is poor, and composite damage is severe, which seriously affects the performance and reliability of the aircraft structure. This paper used the principal stress method to establish a stress model of countersunk riveting, and, based on the analysis of the stress on the structure during the pressure-riveting process, a composite structure rivet was designed. A finite element simulation model of the double-sided countersunk riveting of composite wedge structures’ composite rivets was established. The influences of the structure and the matching parameters of composite rivets on both the plastic flow of pressure riveting and the compressive stress of the structure during the pressure-riveting process were analyzed. The structural parameters and riveting process of composite rivets were optimized. The results show that the composite rivet structure could significantly reduce the contact-compressive stress at the riveting joint by more than 20%, thereby reducing the damage caused by the riveting to the composite material. For 4 mm rivets, an aperture of 4.04~4.06 mm can achieve precise relative interference riveting at 0.6% to 1.0%. Employing a 2.6 mm rivet elongation can exactly fill the countersunk hole of the wedge.
To address stress concentration around the hole caused by the coupled effect of upsetting expansion and axial load in countersunk riveting of composite wing structures, and building on previous work that validated the effectiveness of a novel sleeve-type rivet in reducing contact stresses, this study further investigates the mechanical performance and failure mechanisms of double-flush riveted composite joints using this novel rivet. Through riveting simulations and quasi-static tests, the pull-out strength, shear strength, and fatigue life were systematically evaluated, along with failure mode evolution and fatigue-critical zone distribution. Results show that the sleeve-type rivet reduces the average stress around the countersunk hole by 18% and significantly narrows the high-stress region. The pull-out and shear strengths are improved by 30% and 47.5%, respectively. The failure mode transitions from upsetting-head plastic contraction in conventional joints to shank necking fracture. The fatigue-critical zone shifts from a concentrated distribution along the head-interface line to a dispersed axial pattern, and fatigue life is extended by approximately one order of magnitude. This study provides a mechanical performance basis for engineering application of the novel rivet and offers technical support for achieving low-stress, high-reliability countersunk composite joints.