Within the double-sided countersunk riveting process of aircraft wings with a composite wedge structure, riveting consistency is poor, and composite damage is severe, which seriously affects the performance and reliability of the aircraft structure. This paper used the principal stress method to establish a stress model of countersunk riveting, and, based on the analysis of the stress on the structure during the pressure-riveting process, a composite structure rivet was designed. A finite element simulation model of the double-sided countersunk riveting of composite wedge structures’ composite rivets was established. The influences of the structure and the matching parameters of composite rivets on both the plastic flow of pressure riveting and the compressive stress of the structure during the pressure-riveting process were analyzed. The structural parameters and riveting process of composite rivets were optimized. The results show that the composite rivet structure could significantly reduce the contact-compressive stress at the riveting joint by more than 20%, thereby reducing the damage caused by the riveting to the composite material. For 4 mm rivets, an aperture of 4.04~4.06 mm can achieve precise relative interference riveting at 0.6% to 1.0%. Employing a 2.6 mm rivet elongation can exactly fill the countersunk hole of the wedge.
According to the requirements for the rapid scanning and measurement of the geometric shape during the process of chemical milling of an aviation engine casing, the scanning path of the casing is planned and studied. This paper introduces the principle and method of the tracking scanner and automatic measuring system and analyzes the scanning area range, approach distance, and wide angle of the field. The casing process is modeled by applying part of the machine, obtaining a series of scanning path point and synthesizing the scanning trajectory. On this basis, the entire scanning process is divided into two alternating actions: scanning measurement and posture adjustment, and the mathematical model of the annular scanning path on the outer surface of the casing part is obtained. Adjusting the scan height was used to solve the repeated scan area problem, and the results show that the adjustment method effectively shortened the scan path’s length and time. The simulation method verifies the planned finite ring-scanning path, which verifies the correctness and feasibility of the mathematical model. Through the automatic scanning reconstruction process test, the reconstruction rate of the ring scanning trajectory reaches 85%, which is 80% higher than the manual detection efficiency.
The aim of manufacturing large aerospace parts for the three-dimensional scanning field demands high precision and efficiency. However, it may be more challenging to meet the full coverage of the measurement problems for large aerospace parts with the scanning range of traditional three-dimensional scanning methods. This paper establishes a dynamic posturing scanning measurement system for large aerospace parts with a six-degree-of-freedom posturing platform and a six-degree-of-freedom industrial robot linkage. It establishes a mathematical model of dynamic three-dimensional scanning posturing. It proposes a platform attitude adjustment strategy based on the field of view angle of a 3D scanner during the adjustment of a six-degree-of-freedom platform. The dynamic scanning path planning is carried out using the three-dimensional spatial decomposition method, and the vector coordinates of the critical points at the edges of the missing areas of the scan are used to re-scan the missing areas to establish the dynamic scanning paths of large aerospace parts. It is experimentally verified that the system can realize the dynamic scanning of complex curved large aerospace parts. The experimental results show that the measurement efficiency is improved by more than 75%, and the point cloud coverage of the scanning reconstruction is improved by 18% for large aerospace components with complex surfaces.