A high-peak-power, widely tunable range long-wave infrared optical parametric oscillator (OPO) based on the BaGa4Se7 (BGSe) crystal is demonstrated in this Letter. Pumped by a 1064 nm Nd:YAG laser, a high-peak-power of 0.15 MW was achieved at 9.8 µm with a pulse width of 5.0 ns. At 11.0 µm, a high beam quality of M2x = 4.1 and M2y = 3.3 was achieved. By rotating the BGSe crystal, a broad tuning range of 6.7–13.9 µm was realized. Furthermore, a theoretical analysis was conducted to elucidate the reasons behind the improvement in beam quality in the x-direction as the wavelength of the idler wave increases.
We have investigated the multi-spectral line output characteristics of a CO2 pulsed laser at multi-atmospheric pressure. The pulse waveforms, wavelengths, and energies of the output spectral lines and the small-signal gains of the full spectrum were measured at 3, 4, and 6 atm. To explain the experimental results and predict the output at higher pressure, a modified six-temperature multi-frequency dynamic model of the regular and sequence band lines was developed. The output spectrum varying from the 10P to 9R band with the increase of pressure was studied theoretically and experimentally. In addition, the gains of the 9R(16), 9P(16), 10R(16), and 10P(16) lines at 3 to 14 atm were simulated and measured, providing insights into variation regulation of the four band gains as pressure increases.
Laser pulse amplification by a high-pressure CO2 amplifier in the long-wave infrared (LWIR) spectral range is a feasible technology for strong-field physics research. Crystals such as ZnGeP2 (ZGP) have high nonlinear coefficients and transmittance in the LWIR region, with spectral widths of generated pulses closely matching the gain spectrum of high-pressure CO2 amplifiers. Therefore, ZGP optical parametric oscillation (OPO) may allow higher-efficiency energy extraction in amplifiers, improving the output characteristics of LWIR amplification systems. In this study, the gain measurement of ZGP OPO pulses amplified by a high-pressure CO2 amplifier was carried out for the first time. Single-detector acquisition was utilized to achieve a unified sensor responsivity, and a laser signal-triggered function generator was used to synchronize the seed pulse and amplifier. Six-pass amplification was performed successively, yielding an amplification factor of 4.5 for the peak power and a maximum coefficient of 0.42% cm−1 for the small-signal gain. The gain and loss effect during small-signal amplification were discussed. The potential capability of acquiring ultra-short pulses with ZGP OPO pulses was also explored with the FFT function of MATLAB software.
Laser isotope separation has emerged as a promising technique for the selective separation of 13C isotope, offering a simple setup, high selectivity, and low energy consumption. Contrary to a previous study, we found that increasing the pulse repetition rate to enhance production rate actually leads to a decrease in 13C selectivity. This decline is attributed to energy accumulation within the irradiated region, inducing thermal excitation, increased molecular collision frequency and non-selective dissociation related to V-V, V-R and V-T energy transfers. To eliminate these negative effects, we recommend using an absorption cell with a gas exchange system to guarantee that each laser pulse interacts with fresh gas molecules. The selectivity decline can also be mitigated by using a vibrational relaxer, such as argon. Another alternative to maintain selectivity is increasing the wavelength. The underlying mechanisms are further elaborated through a perspective of molecular dynamics.
By establishing a high-pressure CO2 laser pump system and a liquid nitrogen temperature-controlled multi-pass pool, we systematically investigated the temperature-dependent Raman gain characteristics of para-hydrogen (p-H2) under varying spectral lines and pressures. We report the first demonstration of the temperature–pressure synergistic regulation mechanism on stimulated rotational Raman scattering gain in p-H2. Experimental results revealed the existence of an optimal gain temperature, which shifts toward higher temperatures with increasing pressure (from 117 K at 400 Torr to 133 K at 800 Torr). Theoretical analysis elucidated that the physical mechanism governing this synergistic effect is dominated by the competition between collisional broadening and Doppler broadening. The dynamic equilibrium between these two broadening mechanisms drives the observed rightward shift of the optimal temperature with rising pressure. Numerical simulations show excellent agreement with experimental data. The results show that the Raman gain is increased by 30% at 600 Torr and 125 K compared with traditional liquid nitrogen cooling. Significantly enhancing the stimulated Raman gain coefficient of p-H2 through synergistic temperature–pressure optimization effectively lowers the pump threshold for stimulated Raman scattering. This approach not only reduces the stringent performance requirements for the pump laser source, thereby enhancing system reliability, but also crucially enables the full exploitation of system potential and maximization of system performance without altering the output wavelength or replacing core hardware components.
Optical parametric oscillation (OPO) or optical parametric amplification (OPA) systems offer significant potential for generating high-energy, narrow-pulse laser output, finding applications across various domains. To achieve efficient amplification in cascade with amplifiers, precise frequency domain matching between OPO/OPA systems and amplifiers is imperative. Therefore, preliminary simulation and computation of the spectral characteristics of OPO/OPA systems are of paramount importance in the early stages of experimentation. Currently, the calculation of OPO/OPA output spectrum characteristics is limited to estimating the influence of pump light characteristics on output spectrum linewidth, a consideration that remains incomplete. This paper presents a comprehensive computational approach that takes into account the impact of four crucial factors on the output spectrum characteristics: pump light linewidth, pump light divergence angle, the walk-off effect, and the absorption loss of the crystal. This method finely characterizes the features of the output spectrum. The results obtained through the proposed approach align well with experimental results, underscoring its effectiveness. This study aims to obtain the output spectrum characteristics of BaGa4Se7 OPO/OPA through calculations to provide theoretical guidance for subsequent cascade amplification experiments.