Metal binder jetting shows great potential for medical technology. This potential can be exploited by integrating binder jetting into existing process routes known from metal injection molding. The biggest challenge here is the flowability and packing behavior of the powders used, due to their low size distributions. This paper investigates different powder-drying strategies to improve flowability using a statistical experimental design. Because of its relevance for medical applications, spherical Ti-6Al-4V powder with a size distribution under 25 µm is dried under various parameters using vacuum and gas purging. The investigated parameters, time and temperature, are selected in a central-composite-circumscribed test plan with eleven tests and three center points. The target parameters—water content, flowability and impurity levels (oxygen, nitrogen)—of the powder are analyzed. For validation, practical test trials are carried out on an industrial binder jetting system with unconditioned powder and conditioning with optimized parameters, comparing the manufactured parts and the powder bed. An optimized drying cycle with a duration of 6 h at 200 °C was determined for the investigated powder. Significant improvements in the dimensional accuracy (from ±1.5 to 0.3%) of the components and the visual impression of the powder bed are demonstrated.
15 March 2025 in Journal of the Japan Society of Powder and Powder Metallurgy
Powder in sinter-based metal binder jetting is not fused but only bonded, which in principle ensures full reusability of the unbonded powder. This increases both resource and cost efficiency. In order to explore this potential, this study investigates the effect of powder recycling with regard to handling and thermal influences. For this purpose, a gas atomized Ti-6Al-4V powder is used as a reference powder. It is shown that recycling the Ti-6Al-4V powder four times leads to a minor change in the particle size distribution and an improvement in flow properties. No differences in the average green part densities could be determined, but an increase in their range (from 1 to up to 7 %). Furthermore, it is demonstrated that the thermal influence due to curing and conditioning (temperatures ≤ 200°C) after printing does not lead to a significant increase in oxygen or nitrogen even after 15 repetitions.
In order to enable fast medical response in times of pandemics or other humanitarian crises, decentralized manufacturing networks based on additive manufacturing technologies are suitable for the demand-driven production of protective equipment and medical supplies. The use of mobile manufacturing units is intended to increase the resilience of isolated and overwhelmed hospitals in developing countries. In this paper, a digital assistance system for enabling untrained staff to handle the mobile manufacturing unit as well as operate and maintain 3D printers on site will be discussed.