Laser speckle has a negative effect on laser projectors, so reducing laser speckle is crucial for the development of laser projector displays. We primarily focus on studying the laser speckle contrast of laser projector displays and the mechanism for reducing speckle. Based on the theory of decreasing temporal and spatial coherence of laser light, this report derives the complete formula for calculating speckle contrast in a laser projector display and provides detailed calculation procedures. According to the comprehensive formula, the primary factors influencing speckle contrast encompass wavelength, spectrum, angles of incidence or observation of lasers, the roughness of the screen surface, the number of independent speckle patterns generated by a moving diffuser, and the number of resolution elements within one eye resolution element in the projector lens. Various methods have been used in the projection engine to suppress speckle, and the main factors for reducing speckle have been verified through theoretical calculations and experimental verification. At a testing distance of 700 mm and with an F-number of 41.7 for the detector lens, the RGB laser speckle contrasts were measured to be 9.1%, 7.3%, and 10.4%, respectively, which aligns well with the results obtained from theoretical calculations. Meanwhile, the speckle contrast of the white field was also measured, yielding a result of 5.6%. The speckle contrast becomes imperceptible when the viewing distance exceeds 2000 mm in our projection system.

Near-field bending of a laser diode bar (i.e., the SMILE effect) degrades the laser beam brightness, adversely affecting optical coupling and beam shaping. Previous reports mainly focused on the two-dimensional near-field bending of a laser diode bar. However, the near-field bending of a laser diode bar not only occurs in the laser bar growth direction, but also in the beam propagation direction. The present article proposes the three-dimensional near-field bending of a laser diode array, which is commonly known as the three-dimensional spatial SMILE effect. Through theoretical and simulated investigations, it has been found that a laser bar array not only deforms in the fast axis direction to cause the traditional two-dimensional SMILE effect but also experiences an additional deformation of approximately 2 μm in the laser emission direction simultaneously. Due to the SMILE effect in the beam propagation direction, not all emitters are aligned in a straight line, and some emitters experience defocusing during collimation. Consequently, there is an increase in the residual divergence angle and beam width, resulting in a degradation of the laser bar array’s beam quality. According to the theoretical calculations, ZEMAX simulations, and experimental results, for a FAC (fast axis collimation) with a focal length of 300 μm, the divergence angle of single emitter after collimating in the fast axis increases from 4.95 mrad to 6.46 mrad when the offsetting of the working distance between the incident beam waist and FAC lens increases from 0 μm to 2 μm.

Aiming at the problems of traditional vacuum pre-compression technology, which is difficult to visually observe the material curing effect and low sampling accuracy, this paper independently developed a set of new modular transparent model barrels and controllable vacuum pressure manifolds. Based on traditional experimental methods, Improve the model barrels and vacuum dividers in the experimental system. Experimental research shows that the improved experimental system not only solves the shortcomings of the traditional experimental system, but also can be assembled on site, which is beneficial to the areas with abundant water resources. The project of reclaiming land from the sea provides support, which has certain production and economic benefits.