The rapidly growing world of FPGA devices offers important as well as interesting platforms for analyses of process scaling. It creates also new study opportunities in case of new process variations and degradation effects. Changes in parameters of FPGAs in time or under either power supply voltage or temperature variations result in timing variations or delays and may affect the final design quality and dependability. Such timing variations may result in delay faults, up to the final device or equipment malfunction or failure. FPGA designs must be carefully tested and simulated during the design phase. This area is well-covered by many papers and publications and being investigated again with the new processes coming every approximately 2 years. This paper investigates the area of effects caused by the FPGA chip design and metallization or design trade-offs. The paper presents interesting results obtained during various tests including the important values of the total delays caused by neighboring loaded SLICEs or locations in the FPGA. These results were obtained by a method of frequency and delay measurement, capable of delivering stable results in the range of 0.1ps (100fs), using only inexpensive tools and methods.
This paper presents a method and results from measurement of internal parameters of Xilinx XC7Z020 Zynq device - the programmable microelectronic nanostructures designed on 28 nm TSMC's technology. The presented method utilizes undersampling approach and a very easy way of processing of BRAM data streams. The presented flexible circuits have been used in various measurements of timing parameters delays in FPGAs, up to measurements or detection of the aging issues. The paper presents surprising overview of such measurements with the key result, that the usability of the latest 28 nm devices under accelerated conditions is strictly limited to lower frequencies or significantly lower temperatures. It also significantly limits the possibility of study of aging effects under accelerated conditions and might affect security applications. The paper extends the measurements and results available from previous technology nodes and tries to uncover new information and areas of the latest high-end technologies.
The reliability issue, including aging processes in modern devices with very fine structures and utilizing programmable technologies, being applied in high-performance or dependable systems in various safety, automotive or space applications, is sometimes very difficult to predict, measure or watch. The task is well-mastered in the world of ASIC, the situation is slightly different for FPGA devices. Modern FPGA devices incorporate number of true dual-port memory blocks with 8-T cells, hence offering new options. However, such blocks are typically used for data storage and processing purposes. This paper presents a new way of utilization of the RAM block (BRAM) for the delay fault detection purposes. The BRAM and a simple controller log risky transitions or delay fault events and may positively affect the overall reliability of the device as well as all the system.
This paper presents the manufacturing of a patch antenna using an advanced 3D printing technology called lights-out digital additive manufacturing (LDM). This 3D LDM printing technology is mainly used for printing circuit boards (PCBs); however, it has also been used to print a patch antenna from conductive (CI) and dielectric ink (DI). This 3D LDM-printed antenna was compared with antennas on different dielectric substrates (Arlon 25N and FR4). The obtained results are compared and analyzed in this paper.