The present work includes the fabrication of pure BiFeO3 and Bi0.9Y0.1Fe1−xCuxO3 (x = 0.05, 0.10, 0.15) nanoparticles by the usual sol-gel route. The characterization of structural, morphological, optical, electrical, and magnetic properties of the synthesized samples was achieved through x-ray diffraction spectroscopy, Raman spectroscopy, Fourier transform infrared spectroscopy, scanning electron microscopy, an impedance analyzer, and a vibrating sample magnetometer. The Fourier transform infrared study confirmed the presence of Bi–O and Fe–O bonds. The x-ray diffraction patterns confirmed the rhombohedral (R3c) structure as a major phase with the orthorhombic (Pnma) structure as a secondary phase in all samples, and few amount of impurity phase of Bi25FeO40 was also determined. The surface morphology analysis showed the variation of particle size from 63 to 174 nm. The Raman spectra of 13 optical phonon modes, including 4A1 and 9E symmetric phonons, are observed for all samples, and the positions of these modes are almost similar, except the intensities of A1 modes. The optical measurements show a reduction in bandgap from 2.17 to 2.03 eV with co-doping, revealing itself as a more promising applicant in photovoltaics. An enhanced value of the dielectric constant is observed for different doped samples at different frequency regions from 100 Hz to 10 MHz. Magnetic investigation demonstrates the improved ferromagnetism with co-doping of Y and Cu due to distortion in the FeO6 octahedron. A maximum saturation magnetization of 0.26 emu/gm and a coercivity of 2915 Oe were found for Y concentration of 10% and Cu concentration of 15%.
Ni–Zn-based ferrites (NZFO) need to possess the ideal ratio of dielectric and magnetic characteristics for uses involving electromagnetic fields. Consequently, the NZFO system has been modified by Ti4+ substitution at Fe3+ producing Ni0.5Zn0.5TixFe2−xO4 (x = 0.00, 0.02, 0.04, 0.06, 0.08 and 0.10) and a conventional sol–gel process was followed for the synthesis. The structure of the synthesized samples was evaluated from the X-ray diffraction (XRD) patterns. Fourier transform infrared (FTIR) measurement provided information on chemical interaction with thermodynamic conditions. In addition, the grain sizes were obtained from scanning electron microscopy (SEM). Furthermore, the studied samples exhibit a notable light absorption in the visible spectrum with band gaps between 3.8 and 4.8 eV. The magneto-dielectric properties were analyzed by field (H) dependent magnetization (M), frequency-dependent permeability (μ), and permittivity (ε) measurements. Ti4+ substitution in NZFO led to a decrease in magnetic saturation (Ms) and μ while the values of creased and improved the mismatching impedance (Z/η0 = (μ′/ε′)1/2). The lowest value of Ms (14 emu g−1) is achieved for the sample with x = 0.1 for which μ is also the lowest. Finally, a stable value of Z/η0 (∼4.0) has been obtained for the x = 0.10 sample over a wide range of frequencies (1–10 MHz), making it suitable as a miniaturizing device material in this frequency range.
25 September 2014 in International Journal of Applied Sciences and Biotechnology
The experiment was conducted in experimental Farm, Sher-e-Bangla Agricultural University, Bangladesh from July to December 2011 to study the variability of advanced lines of fine rice with correlation and path co-efficient of yield and yield contributing characters. Seven newly developed lines viz. S-1, S-2, S-5, AL-33(II), AL-36, AL-42(II), AL-44(I) and Chinigura. Grain yield/plant of newly developed advanced fine rice lines and check showed positive association in respect of number of effective tillers/hill (0.308), number of filled spikelets/panicle (0.110) and weight of 1000-grains (0.109), whereas significant negative association with panicle length (-0.609), number of unfilled spikelets/panicle (-0.542) and non significant negative association with plant height (-0.136) and number of ineffective tillers/hill (-0.304). Path analysis revealed that plant height had positive direct effect (0.154), number of effective tillers/hill had positive direct effect (0.065), number of ineffective tillers/hill had negative direct effect (-0.114), panicle length had positive direct effect (0.163), number of filled spikelets/panicle had positive direct effect (0.285), number of unfilled spikelets/panicle had negative direct effect (-0.154), weight of 1000-grains had positive direct effect (0.234) on grain yield/plant. DOI: http://dx.doi.org/10.3126/ijasbt.v2i3.11069Int J Appl Sci Biotechnol, Vol. 2(3): 364-370
2 April 2025 in Chemical Engineering Journal Advances