A double-sided 1200-V/600-A multichip half-bridge insulated gate bipolar transistor (IGBT) module was fabricated utilizing molybdenum as stress-relief buffer and sintered nanosilver as die-attachment. By using the double-sided packaging, the volume, parasitic inductance, and junction temperature were decreased significantly, thus the higher power density could be achieved. However, the thermo-mechanical stress was also increased. In this study, molybdenum instead of the most common copper was used as stress-relief buffer between chips and substrate, thus the thermo-mechanical stress decreased greatly without significant increasing junction temperature. Specifically, by using molybdenum instead of copper as buffer material, the simulation results showed that the IGBT junction temperature at total power loss of 200 W only increased by 5.2% (2.22°C) but the corresponding thermo-mechanical stress decreased by 9.8% (5.58 MPa), and the sintering residual stress decreased by 20.1% (48.88 MPa). Thermal performance, static and dynamic electrical performance, and reliability via power cycling test of the doublesided module were also characterized experimentally. No degradation of the power devices proved that the way to doublesided packaging power devices could be used for future manufacturing of high power density power module.
Die attachment by pressureless silver sintering at <; 200 °C is significant for power electronic packaging because it can relieve residual thermo-mechanical stress and avoid chip damage. In this letter, we developed a trimodal-silver paste capable of pressureless sintering at as low as 180 °C due to the usage of trimodal-system and 170 °C removable organics agents. The bondline could be densified by neck-formation as expected. Thanks to the high packing density of the trimodal system, a high bonding strength of 35 MPa was achieved. Moreover, IGBT modules were demonstrated using the 180 °C sinterable sintered-Ag die attachment. The output I-V characteristics and the thermal resistance of the IGBT modules were discussed.
Low-temperature silver (Ag) sintering is emerging as a cutting-edge die-attach technology for power electronics packaging. However, the industry still has concerns about completely accepting this technology. One of the reasons is a lack of knowledge about the mechanism and process of sintered silver bonding on various metallization. Before, we reported a preliminary assessment of the die-shear strength and microstructures of Si dummy device attached on Ag, Au, and Cu metallization. This research will go deeper into the practice and science of attaching Si and SiC devices with sintered-Ag on substrates with up to seven most widely used metallizations, including electroplated Ag, Ni/Au, and Ni, electroless-plated Ni(P)/Ag, Ni(P)/Au, and Ni(P), and native Cu on DBC substrate. All sintered-Ag die-attach were pressureless in the air at temperatures ranging from 220 °C to 300 °C. The mechanical, electrical, and thermal parameters, as well as the microstructural analyses, were assessed. The purpose of this research is to gain a better understanding by: 1) discussing effects of devices and substrate metallizations on the mechanical, electrical, and thermal characteristics; 2) reviewing fundamental mechanisms of interfacial adhesion for sintered-Ag bonding, and 3) providing practical considerations for developing Si and SiC sintered-Ag die-attaching profiles on the widely used substrate metallization.