External interference in ionospheric sounding seriously degrades the quality of echo signals and data; thus, it should be eliminated. This paper presents a method for suppressing interference using chaotic coding with a set of Bernoulli map sequences; compared with other commonly used coding methods such as Barker code, complementary code, and Barker-like codes, through simulation, the ambiguity function (AF) of Bernoulli map codes has better performance in terms of peak sidelobe level (PSL), integral sidelobe ratio (ISL), noise suppression (NS), and signal-to-noise ratio (SNR). Experimental tests were performed using a vertical ionosonde in Yinchuan, Ningxia Hui Autonomous Region, China, and the ionosonde was operated by alternating 40-bit Barker-like coding and 40-bit Bernoulli map coding each day to compare the effectiveness of interference suppression. The results showed that using Bernoulli map coding could remove interference and improve SNR significantly, thereby improving the data quality of the resulting ionograms.

In this paper, a matching method for altimeter and transponder signals in Sub-optimal Maximum Likelihood Estimate (SMLE) tracking mode is proposed. In the in-orbit calibration of the altimeter in SMLE tracking mode using the reconstructive transponder, it is necessary to separate the forwarding signal from the ground echo signal. At the same time, the fluctuations in the received signal of the altimeter, which are caused by the forwarding signal of the transponder, can be eliminated. The transponder generates a bias when measuring the arrival time of the transmitting signal from the altimeter and embeds this bias in both the transponder-recorded data and the altimeter-recorded data. Therefore, the two sets of data have one-to-one correspondence, and they are superimposed using the sliding sum method. Moreover, the distance between the altimeter and the transponder is a parabolic geometric relationship, and the outliers are eliminated by the fitting error minimization decision, and the transponder signal is separated from the ground echo. The final altimeter transmitting–receiving signal path is obtained. Furthermore, the principles underlying this method can be used for any transponder that can adjust the response signal delay during calibration.