Synthetic aperture passive positioning (SAPP) has gradually become a research hotspot in the field of single-station passive positioning. Except for the acoustic band, almost all research in the microwave band only focuses on the spaceborne scenarios. In this paper, we attempt to extend SAPP to more scenarios, such as airborne and vehicle-mounted applications, and introduce the motion error problem. The difficulty is that, different from the problem of SAR motion compensation, the target area of passive positioning is unknown, and the compensation matrix cannot be calculated directly. We propose an iterative motion compensation (IMC) algorithm to solve it. Both simulation and vehicle experiment results verify the effectiveness of the IMC algorithm. The results show that IMC improves the positioning accuracy by two orders of magnitude in the presence of motion error and exhibits strong convergence

In unmanned aerial vehicle (UAV)-based time difference of arrival (TDOA) positioning technique, baselines are limited due to communication constraints. In this case, the accuracy is highly sensitive to the TDOA measurements’ error. This article primarily addresses the problem of short-baseline high-precision time synchronization and TDOA measurement. We conducted a detailed analysis of error models in TDOA systems, considering both the time and phase measurement. We utilize the frequency division wireless phase synchronization technique in TDOA systems. Building upon this synchronization scheme, we propose a novel time delay estimation method that relies on phase measurements based on the integer least squares method. The performance of this method is demonstrated through Monte Carlo simulations and outdoor experiments. The standard deviations of synchronization and TDOA measurements in experiments are 1.12 ps and 1.66 ps, respectively. Furthermore, the circular error probable (CEP) accuracy is improved from 0.33%R to 0.02%R, offering support for the practical application of distributed short-baseline high-precision passive location techniques.

With the rapid development of lightweight unmanned aerial vehicles (UAVs), the combination of UAVs and ground moving target indication (GMTI) radar systems has received great interest. In GMTI, moving target relocation is an essential requirement, because the positions of the moving targets are usually displaced. For a multichannel radar system, the position of moving targets can be accurately obtained by estimating their interferometric phase. However, the high position accuracy requirements of antennas and the computational resource requirements of algorithms limit the applications of relocation algorithms in UAV-borne GMTI radar systems. In addition, the clutter’s interferometric phase can be severely affected by the undesired phase error in the site. To overcome these issues, we propose an improved knowledge-based (KB) algorithm. In the algorithm, moving targets can be relocated by comparing their interferometric phase with the clutter’s phase. As for the undesired phase error, the algorithm first employs a random sample consensus (RANSAC) algorithm to iteratively filter the outliers. Compared with other classic relocation algorithms, the proposed algorithm shows better relocation accuracy and can be applied in real-time applications. The performance of the proposed improved KB algorithm was evaluated using both simulated and real experimental data.

Unmanned Aerial Vehicle (UAV)-based distributed Synthetic Aperture Radar (SAR) is a current research focus. Phase synchronization is crucial for eliminating the non-coherence of distributed systems. However, as the number of UAVs increases, fast time-varying multipath effects caused by rotors can lead to multipath fading. This degrades the signal-to-noise ratio (SNR) of the synchronization link and distorts the synchronization waveform. It further breaks the reciprocity of the dual one-way synchronization link, ultimately degrading phase synchronization accuracy. We propose a robust method for spike detection and error propagation to improve phase synchronization precision. Using the Hampel filter, we detect pulse peak position jitter and remove observations from anomalous links. We then use data fusion based on minimum variance to recover synchronization errors in these links, leveraging the redundancy in synchronization phase matrices. The effectiveness of the proposed method is confirmed through flight test data from a four-UAV distributed TomoSAR experiment. Compared to the maximum-peak detection method, the phase accuracy is improved from 12.84 deg to 0.61 deg. This method supports the application of distributed SAR.

High-precision, robust, and rapid three-dimensional (3D) passive positioning of the radiation source is critical for modern reconnaissance systems. While synthetic aperture technology has advanced 2D passive positioning performance, existing methods fail to achieve full 3D positioning with sufficient accuracy and computational efficiency. This is because of the inherent limitations of the single-station platform in resolving elevation-angle ambiguity. To address this gap, we propose a Cross-Track Interferometric Synthetic Aperture (CISA) 3D passive positioning algorithm. The algorithm innovatively realizes robust elevation-angle measurement by recursively deriving the long baseline unambiguous phase difference step-by-step from a virtual short baseline. The 3D positioning is achieved by combining passive synthetic aperture and interferometric angle measurement. Furthermore, we establish the incoherence model of synthetic aperture passive positioning for the first time and propose a compensation method based on static acquisition data to improve the practicability of CISA. Simulation and experimental results demonstrate that the proposed CISA algorithm achieves a positioning accuracy of 4.73‰R, improves computational efficiency by 1–2 orders of magnitude compared to conventional methods, and exhibits superior robustness to noise. The research can provide a reference for the method research and engineering realization of synthetic aperture 3D passive positioning.

Synthetic aperture radar (SAR) systems, as wideband radar systems, are inherently susceptible to interference signals within their operational frequency band, which significantly affects SAR signal processing and image interpretation. Recent studies have demonstrated that semiparametric methods (e.g., the RPCA method) exhibit excellent performance in suppressing these interference signals. However, these methods predominantly focus on processing SAR’s raw echo data, which does not satisfy the sparsity requirements and entails extremely high computational complexity, complicating integration with imaging algorithms. This paper introduces an effective method for suppressing interference signals by leveraging the sparsity of the SAR image domain. It utilizes the sparsity of the interference signal in the two-dimensional frequency domain, following focusing processing, rather than relying on low-rank properties. This approach significantly reduces the computational complexity. Ultimately, the effectiveness and efficiency of the proposed algorithm are validated through experiments conducted with simulated and real SAR data.