Although seafloor massive sulfide (SMS) deposits are crucially important metal resources that contain high‐grade metals such as copper, lead, and zinc, their internal structures and generation mechanisms remain unclear. This study obtained detailed near‐seafloor images of electrical resistivity in a hydrothermal field off Okinawa, southwestern Japan, using deep‐towed marine electrical resistivity tomography. The image clarified a semi‐layered resistivity structure, interpreted as SMS deposits exposed on the seafloor, and another deep‐seated SMS layer at about 40‐m depth below the seafloor. The images reinforce our inference of a new mechanism of SMS evolution: Upwelling hydrothermal fluid is trapped under less‐permeable cap rock. The deeper embedded SMS accumulates there. Then hydrothermal fluids expelled on the seafloor form exposed SMS deposits.
The physical properties of seafloor massive sulfides are crucial for interpreting sub-seafloor images from geophysical surveys, shedding light on the evolution of seafloor mineral deposits. While some studies have explored the relationship between electrical properties and the volume of conductive minerals in rocks from seafloor massive sulfide deposits, they primarily focused on artificial samples, leaving the characteristics of natural samples less understood. Moreover, there has been no comprehensive study detailing the general characteristics of electrical properties, particularly chargeability and relaxation time, in relation to the volumetric fraction of sulfides in rocks from massive sulfide mounds in typical hydrothermal areas. In this study, we employed complex conductivity measurements, elemental concentration analysis, and mineral content identification on to rock samples from the active hydrothermal zones of the Okinawa Trough in Japan. The complex conductivity observed was remarkably high, with a pronounced imaginary component and a broad frequency range. This is attributed to induced polarization extending beyond our measurement range. The rock samples were rich in conductive sulfide minerals such as pyrite, chalcopyrite, and galena. Using the Cole–Cole rock physics model, we established a correlation between rock chargeability and relaxation time coefficient with the volume fraction of conductive sulfide minerals, which deviated from previous findings. The intensity of induced polarization was notably higher than anticipated in earlier studies using artificial samples. Furthermore, we observed a distinct positive correlation between the coefficient of relaxation time and the increase in sulfide volume, likely due to the geometric characteristics of the sulfide minerals. Our findings suggest that rocks in massive sulfide mounds may generally construct sulfide clusters that lengthen the conductive path of the electrical carrier. Graphical Abstract
25 March 2025 in Geophysical Journal International
SUMMARY: The interpretation of subsurface resistivity structures in volcanic areas remains challenging and requires the selection of the most plausible configuration from various geological features that affect the resistivity measurements. A comprehensive physical study of the rocks in the target area is essential for accurate interpretation. A magnetotelluric (MT) survey conducted in the southeast flank of Mt. Ontake volcano detected several kilometres of low resistivity below 30 Ωm. However, the interpretation of resistivity anomalies remains to be verified; borehole data have been used to resolve this problem. In this study, geological, fracture, temperature and resistivity structures obtained from borehole investigations were analysed using rock physical methods, and core samples were subjected to physical property measurements and microscopic observations. The geology observed in the borehole was sedimentary rock with a porosity of less than a few per cent, except for the surface volcanic breccia and some intrusive granites. The borehole wall was poorly fractured. The groundwater temperature in the borehole was aligned with the standard geothermal gradient, 40 °C at a depth of 800 m. These results indicate the absence of a hydrothermal reservoir at the site. In contrast, the core samples contained pyrite-filled microfractures. All the samples had poor porosity and contained a small amount of clay minerals but showed uniformly lower resistivity values than expected for similar porosity. Some samples exhibited robust induced polarization effects. The pyrite contents of the samples were low. A pseudo-high-frequency conductivity model test using electrostatic field analysis on a numerical model of microfractured rock properties reproduced the low resistivity observed in the borehole investigation and MT survey. The specifically low-resistivity values observed were appropriately reproduced. The findings of this study indicate that pyrite filling the microfractures can be a major contributor to the low resistivity below 1 Ωm in the study area and suggest that it is necessary to consider the network of microscale veins formed by conductive sulfide minerals, mainly pyrite, for the interpretation of subsurface resistivity in geothermal areas.
This dataset contains fundamental measurements and analyses of rock samples collected from seafloor hydrothermal fields, with a focus on their physical and electrical properties. The dataset includes porosity and particle density measurements obtained via the buoyancy method and complex impedance data acquired through potentiostat-based electrochemical impedance spectroscopy with frequency sweeps. Additionally, impedance data provides Cole-Cole fitting analyses and corresponding graphical representations, which are essential for understanding the polarization characteristics of rock samples. Rocks in seafloor hydrothermal field often exhibit unique properties that are distinct from those of terrestrial rock physics models, necessitating specialized datasets for the accurate interpretation of seafloor geophysical and electromagnetic exploration. This dataset aims to bridge this gap by offering comprehensive data to aid in the interpretation of resistivity structures and improve rock physics models for seafloor hydrothermal systems. The data and figures provided herein are expected to facilitate advancements in the study of seafloor hydrothermal deposits and their resource potential.
Many studies have been conducted to analyse dielectric polarisation and the complex electrical conductivity characteristics by the Cole–Cole type relaxation approximating rocks with a uniform material. That method has revealed the correlation between metal contents and chargeability, between the central relaxation time and the metallic particle size, and so on. Based on the model’s success, such models have been extended to those with multiple capacitances. However, these models cannot represent the mechanism of electrical flow in rocks using equivalent circuits and cannot explain the electrical behaviour of rocks that deviates significantly from the assumptions of the models. Therefore, in this study, by re-evaluating Pelton’s equation, we strove to formulate an appropriate multiple-capacitance model expressed by an equivalent circuit, with the aim of ascertaining electrical features more easily and properly than through the convolution of electrical response functions. We achieved theoretical expansion of Pelton-type formulae to multiple capacitances. Our Double-Pelton equivalent circuit model (DPM) was applied to the observed complex conductivity curves of artificial samples including pyrite. The obtained parameters of our DPM were found to have a good correlation to the rock features. We achieved to show that the conductive mechanism of the complex geometrical features of rock samples can be modelled simply and effectively. The continuous efficiency of sulphide particles in the direction of the electric field, and pyrite particles which can act as bottleneck conductors as in percolation theory, are found to be playing an important role in electric conduction.