Juyeon Lee

Ms. Juyeon Lee


Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
7 May 2024 in Electronics
Verified
Journal Article
Open access
PDF file
JLJuyeon Lee
Juyeon Lee
June-Seok LeeJune-Seok Lee
June-Seok Lee
This paper proposes an improved zero-current distortion compensation (IZCDC) method for the Vienna rectifier. The conventional zero-current distortion compensation (ZCDC) method modifies the reference voltages by adding an offset voltage to compensate for the zero-current distortion (ZCD). However, the reference voltages occasionally exceed the linear modulation region by the offset voltage added at the driving start-point of the Vienna rectifier, where the modulation index of phase voltage is relatively large. This causes a hard-start of the Vienna rectifier accompanied by a serious surge and distortion in the phase current. In this paper, the IZCDC method is proposed for achieving the soft-start of the Vienna rectifier. When the overmodulation occurs, the proposed method modifies the conventional offset voltage to the IZCDC component, which is involved in the adjustment of the variance of the phase current, only for a certain phase among the three phases. As the IZCDC component regulates the variance of the phase current to zero, surge and distortion in the phase current can be mitigated. As a result, the Vienna rectifier starts its operation softly while ensuring its normal operation in the transients. The effectiveness of the proposed method is verified through simulations and experimental results.

13 November 2025 in IEEE Transactions on Power Electronics
Verified
Journal Article
Closed access
JLJuyeon Lee
Juyeon Lee
YGYoung-Min Go
Young-Min Go
June-Seok LeeJune-Seok Lee
June-Seok Lee
In the Vienna rectifier, a common issue of discontinuous pulsewidth modulation (DPWM) methods is that the clamping operations induce significant neutral-point (NP) voltage fluctuations that lead to distortion of the input current. In this article, a carrier-based DPWM method with dynamic clamping state selection (DCSS) for NP voltage balance is proposed. The proposed method selects a combination of a certain phase and switching state as a clamping operation to mitigate the NP voltage imbalance. The selection of the combination is determined based on the theoretically estimated NP voltage instead of the sensed one, which enables the proposed method to be implemented independent of the voltage sensor accuracy. In addition, an alternative PWM sequence is proposed to minimize additional switching losses by considering the operation of DCSS. The validity of the proposed method is verified through experiments.

5 January 2026 in Applied Sciences
Verified
Journal Article
Open access
PDF file
ELEunWoo Lee
EunWoo Lee
JLJuyeon Lee
Juyeon Lee
June-Seok LeeJune-Seok Lee
June-Seok Lee
This paper proposes a reliable control strategy for dual induction motor drives using a five-leg inverter (FLI). Since the FLI has the structural characteristic where both motors share a common leg, the current of the common leg can flow at twice the magnitude of the other leg currents. To prevent this overcurrent, this paper proposes a reliable integrated control strategy for both normal and open-circuit fault conditions in the FLI. Under normal conditions, overcurrent can occur when the phase and frequency of the current for both motors are distinct; therefore, the angle controller and current limitation prevent overcurrent. In contrast, an open-circuit fault in the FLI can cause overcurrent due to altered current paths. To ensure a safe shutdown, identifying the specific location of the faulty switch is essential. Therefore, fault diagnosis is required using the stator currents. Once the fault is located, a fault-tolerant method is applied to safely stop the motors, considering both the fault location and the rated current of the common leg. Consequently, the proposed system enables reliable operation of dual induction motor drives under various conditions. The experimental results verify the effectiveness of the proposed system.