The U-shaped fiber configuration represents the elementary form of micro-displacement sensing, characterized by its exceptional freedom and flexibility. The study proposes the U-shaped bent single-mode–multimode–single-mode (SMS) fiber structure that integrates the multimode interference (MMI) effect for enhanced mode dispersion and the Mach–Zönder interference (MZI) effect for spectral sensitivity improvement. The transmission spectral properties of the U-shaped SMS fiber structure with a bent radius over 1 are experimentally measured as the change in displacement varied within the range of 5 in this work. As the radius decreases, the spectrum shows redshift, which is related to the central wavelength of the peak or dips—a smaller wavelength results in a stronger redshift for the same displacement change. The average sensitivity of micro-displacement measurement within a range of 5 is 5.41 , and the linearity is 99.62%. The maximum sensitivity of U-shaped SMS fiber structure is 34.46 , with the minimum displacement change of approximately 5.804 . The transmission spectral properties of the U-shaped SMS fiber structure within the ranges of 50 , 500 , and 5 mm are experimentally measured in this work. This experiment observed a relatively uniform spectral drift pattern in a large range of micro-displacement sensing. The measurement range is limited by the limited spectral range of the light source and the discontinuous variation in the effective refractive index. This provides an experimental reference for further understanding the characteristics of U-shaped fiber structures and applying its application in micro-displacement sensing.
Magnetic anapole states associated with the destructive interference between magnetic dipole and magnetic toroidal moments result in suppressed scattering accompanied by strongly enhanced near fields. Here, we demonstrate the existence of such modes in the gap of a gold oblate nano-ellipsoid on gold mirror (ONEOM) structures and observe a pronounced Purcell factor enhancement for magnetic dipole radiation upon introducing magnetic dipoles into the gap. We systematically investigate the dependence of the magnetic radiation Purcell factor on gap size and structural parameters. Notably, a 230-fold Purcell factor enhancement is achieved for the ONEOM configuration. This result highlights the potential of ONEOM structures in applications requiring efficient magnetic dipole emission, including nonlinear frequency conversion, plasmonic sensing, and single-photon sources.
Localized surface plasmon resonance (LSPR)-based sensors exhibit enormous potential in the areas of medical diagnosis, food safety regulation and environmental monitoring. However, the broadband spectral lineshape of LSPR hampers the observation of wavelength shifts in sensing processes, thus preventing its widespread applications in sensors. Here, we describe an improved plasmonic sensor based on Fano resonances between LSPR and the Rayleigh anomaly (RA) in a metal–insulator–metal (MIM) meta-grating, which is composed of silver nanoshell array, an isolation grating mask and a continuous gold film. The MIM configuration offers more freedom to control the optical properties of LSPR, RA and the Fano resonance between them. Strong couplings between LSPR and RA formed a series of narrowband reflection peaks (with a linewidth of ~20 nm in full width at half maximum (FWHM) and a reflectivity nearing 100%) within an LSPR-based broadband extinction window in the experiment, making the meta-grating promising for applications of high-efficiency reflective filters. A Fano resonance that is well optimized between LSPR and RA by carefully adjusting the angles of incident light can switch such a nano-device to an improved biological/chemical sensor with a figure of merit (FOM) larger than 57 and capability of detecting the local refractive index changes caused by the bonding of target molecules on the surface of the nano-device. The figure of merit of the hybrid sensor in the detection of target molecules is 6 and 15 times higher than that of the simple RA- and LSPR-based sensors, respectively.
The ring cavity fiber laser with saturable absorption fibers is a simple and practical technical way of achieving single-frequency laser output. However, this structure cannot obtain wavelength-tunable laser output. In this work, an external injection locking signal launched by tunable LD is used to optimize the tunability in single-frequency ring cavity fiber lasers. By aligning the external injection signal, tunable laser output ranging from 1544.13 to 1546.51 nm is achieved. The maximum output is 16.5 mW and the linewidth is less than 6.15 kHz. The operation process and the linewidth compression effect of external Injection signals are investigated. The results indicate that there is a correlation between the output signal-to-noise ratio and the output linewidth, and this wavelength-tuning structure has the potential for rapid tuning. This work provides a technical solution for achieving a tunable single-frequency laser in the ring cavity structure.
Metasurfaces have drawn extensive research attention for their unique optical properties and vast application potential. Among the various resonant modes induced in metasurfaces, BIC and electric anapole modes stand out as particularly interesting due to their distinctive physical characteristics. In this work, we designed and investigated novel dimeric dumbbell-shaped metasurfaces incorporating two independently tunable asymmetric parameters. This structural innovation enables the simultaneous excitation of both electric anapole and QBIC modes under normally incident MIR illumination. More importantly, by adjusting these two asymmetric parameters, one can independently tune the resonance peaks of the two modes, thereby overcoming the performance limits of conventional single-peak modulation. This metasurface design demonstrates outstanding performance for dielectric environment-sensing applications. We conducted a comprehensive investigation of the sensing sensitivity for dumbbell-shaped metasurfaces of various geometries. Our simulation results show that the circular-shaped configuration achieved high sensitivity, reaching 20,930 GHz/RIU. This work offers a novel design paradigm for multi-mode control and functionalization of metasurface structures.
A hybrid double cladding erbium–ytterbium co-doped fiber (EYDF) amplifier with a single-mode-multimode-single-mode (SMS) active fiber is demonstrated in this study. The hybrid gain fiber with an SMS structure is composed of two kinds of EYDFs with 6 and 12 μm core diameters. The transmission spectra of the SMS fiber structure were theoretically analyzed and the simulation results indicated that the maximum loss in the 1~1.1 μm band where the Yb-band amplified spontaneous emission (Yb-ASE) located, was much larger than that of the 1.5-μm band because of the wavelength difference. The power performance and spectra properties of the hybrid fiber amplifier were theoretically and experimentally analyzed and compared with a typical uniform fiber amplifier under the same conditions. The experimental results demonstrated that this hybrid fiber amplifier can suppress the Yb-ASE by over 12 dB and increase the slope efficiency by more than 2%, but the ASE in the 1.5-μm band increases by 2~3 dB. This work provides a possible method to enable EYDF amplifiers to suppress the Yb-ASE and overcome the pump bottleneck effect.