The enhancement of carbon-supported components is a crucial factor in augmenting the interplay between carbon-supported and metal-active components in the utilization of catalysts for direct ethanol fuel cells (DEFCs). Here, we propose a strategy for designing a catalyst by modifying candle soot (CS) and loading nickel onto ordered carbon soot. The present study aimed to investigate the effect of the Ni nanoparticles content on the electrocatalytic performance of Ni–CS, ultimately leading to the identification of a maximum composition. The presence of an excessive quantity of nickel particles leads to a decrease in the number of active sites within the material, resulting in sluggishness of the electron transfer pathway. The electrocatalyst composed of nickel and carbon support, with a nickel content of 20 wt%, has demonstrated a noteworthy current activity of 18.43 mA/cm2, which is three times that of the electrocatalyst with a higher nickel content of 25 wt%. For example, the 20 wt% Ni–CS electrocatalytic activity was found to be good, and it was approximately four times higher than that of 20 wt% Ni–CB (nickel–carbon black). Moreover, the chronoamperometry (CA) test demonstrated a reduction in current activity of merely 65.80% for a 20 wt% Ni–CS electrocatalyst, indicating electrochemical stability. In addition, this demonstrates the great potential of candle soot with Ni nanoparticles to be used as a catalyst in practical applications.
1 November 2021 in IOP Conference Series: Earth and Environmental Science
Methylene blue dyes are widely used in textile, batik, plastic, paper, and many other industries. The remain of methylene blue dyes in the textile waste is hazardous for health and the environment. Therefore, it takes effort to deal with it. One of the efforts is the process of adsorption using adsorbents. In this study, the adsorbent ZrSiO4/Fe2O3 was synthesized using the coprecipitation method using NaOH as precipitant. Either ZrSiO4 or Fe2O3 was synthesized from Indonesia mineral local zircon sand and jarosites, respectively. The composites of ZrSiO4/Fe2O3 were prepared in %mole variation, which is 75:25; 50:50; and 25:75. All obtained composites were then characterized using X-Ray Diffraction (XRD). The XRD analysis showed that the crystal structure formed was tetragonal for ZrSiO4 and hexagonal for Fe2O3 (also known as α-Fe2O3). Evaluation toward isotherm adsorption and kinetic adsorption showed that the adsorption of MB using ZrSiO4/Fe2O3 follows the Langmuir isotherm model and pseudo-second-order model, respectively.