Highly selective etching of silicon nitride (Si3N4) and silicon dioxide (SiO2) has received considerable attention from the semiconductor community owing to its precise patterning and cost efficiency. We investigated the etching selectivity of Si3N4 and SiO2 in an NF3/O2 radio-frequency glow discharge. The etch rate linearly depended on the source and bias powers, whereas the etch selectivity was affected by the power and ratio of the gas mixture. We found that the selectivity can be controlled by lowering the power with a suitable gas ratio, which affects the surface reaction during the etching process. X-ray photoelectron spectroscopy of the Si3N4 and QMS measurements support the effect of surface reaction on the selectivity change by surface oxidation and nitrogen reduction with the increasing flow of O2. We suggest that the creation of SiOxNy bonds on the surface by NO oxidation is the key mechanism to change the etch selectivity of Si3N4 over SiO2.
28 February 2025 in Journal of Physics D: Applied Physics
Electrode slurry coatings on the current collector of a Li-ion battery suffer from high mass loading owing to the severe floating of the binder during solvent drying. Atmospheric plasma pretreatment of the Cu current collector forms a functional group on its surface, which forms a hydroxyl bond with the binder materials. However, the Cu foil transferred to a high-speed roll-to-roll machine undergoes displacement due to wrinkling. This foil displacement deteriorates the uniformity of the process results and the discharge stability. To overcome the above-mentioned limitations, in this study, we designed an L-shaped dielectric barrier discharge (DBD) reactor as a combination of the direct-type DBD reactor with high processing speed and a jet-type DBD reactor with high discharge stability for industrial-scale current collector pretreatment. Helium gas injected between a pair of L-shaped electrodes and an electrode with bipolar high-voltage power generated stable seed electrons, which led to a homogeneous discharge between the lower part of the L-shaped electrode and the high-speed moving Cu current-collector surface. The plasma-treated Cu current collector exhibited stronger solvent adhesion and improved surface tension. In addition, the graphite anode coated on the plasma-treated current collector showed high mechanical adhesion strength with the anode materials and high-capacity retention in the half-cell test.
1 March 2025 in Japanese Journal of Applied Physics
We propose a flexible and thin patch-type plasma resonance spectroscopy probe enough to be attached to different chamber surfaces. The patch probe, composed of thin metal and dielectric layers, can measure the plasma electron density near any surface in contact with plasma in the chamber. We confirmed that the patch probe can obtain a distribution of the electron density on different chamber surfaces where the probe is attached, namely the chuck, chamber wall, and bottom. From the results, we found variations in electron density depending on the location in the chamber under different RF power and pressure.
We demonstrated the feasibility of die-level process monitoring using spatially resolvable optical emission spectrometers (SROESs) in a low-pressure plasma reactor. The spatially resolved Ar emission line intensities and their intensity ratios were obtained from uniformly generated and intentionally perturbed plasma by inserting conductors of known sizes at known locations. The sheath and perturbed plasma distributions were identified from the Ar emission line intensity and their intensity ratio in the lateral direction to the SROES installment orientation. However, the resolution in the axial direction was insufficient to identify the sheath and perturbed the plasma distribution. We propose the superimposition of measured plasma emission intensities from two perpendicularly aligned SROESs for die-level process monitoring. The insufficient axial resolution can be compensated for by the lateral resolution of another SROES, and die-level process monitoring using SROES can thus be realized.