We analyze the dc Josephson effect in a ballistic superconductor/ferromagnet/superconductor junction by means of the Bogoliubov\char21{}de Gennes equations in the quasiclassical Andreev approximation. We consider the possibility of ferromagnetism originating from a mass renormalization of carriers of opposite spin, i.e., a spin bandwidth asymmetry. We provide a general formula for Andreev levels that is valid for arbitrary interface transparency, exchange interaction, and bandwidth asymmetry, and we analyze the current-phase relation, free energy, and critical current in the short junction regime. We compare the phase diagrams and the critical current magnitudes of two identical junctions differing only in the mechanism by which the midlayer becomes magnetic. We show that a larger number of 0-$\pi${} transitions caused by a change in junction width or polarization magnitude is expected when ferromagnetism is driven by spin bandwidth asymmetry compared to Stoner magnetism. Moreover, we show that these features can be present also for ferromagnets of the Stoner type having only a partial bandwidth asymmetry.
We compute self-consistently the Josephson current in a superconductor-antiferromagnet-superconductor junction using a lattice model, focusing on $0-$\pi${}$ transitions occurring when the width of the antiferromagnetic region changes from an even to an odd number of lattice sites. Previous studies predicted $0-$\pi${}$ transitions when alternating between an even and an odd number of sites for sufficiently strong antiferromagnetic order. We study numerically the magnitude of the threshold value for this to occur, and also explain the physics behind its existence in terms of the phase shifts picked up by the quasiparticles constituting the supercurrent in the antiferromagnet. Moreover, we show that this threshold value allows for pressure-induced $0-$\pi${}$ transitions by destroying the antiferromagnetic nesting properties of the Fermi surface, a phenomenon which has no counterpart in ferromagnetic Josephson junctions, offering a way to tune the quantum ground state of a Josephson junction without the need for multiple samples.
9 May 2022 in IEEE Transactions on Dielectrics and Electrical Insulation
Changing the current loading of mass-impregnated non-draining power cables causes the pressure in the insulation to vary over a wide range. It is generally recognized that under certain conditions—typically after a large load reduction—the pressure becomes so low that shrinkage cavities (voids) form in the insulation, and that partial discharges that may damage the insulation ignite. A finite element model for temperature, electric field and pressure dynamics throughout the insulation layer has been developed. Comparisons with previously obtained measurements on full-scale HVDC subsea cable samples subjected to a variety of loading patterns, external pressures (sea depths) and ambient temperatures, show that the model replicates the pressure behavior of the insulation reasonably well. Most importantly, the complicated viscoelastic properties of the lead sheath, which have a profound effect on the internal pressure dynamics and thereby on the prospects of forming potentially harmful cavities, appear to be sufficiently accurately modelled.
The electrification of society, increasing renewable energy sources and mobility charging lead to new loading patterns for power transformers. Dynamic load conditions induce enhanced mechanical stress on the transformers’ windings, potentially causing degradation of the solid insulation over time and compromising the transformer’s short-circuit withstand capability. Thermal expansion of the windings, caused by losses in the copper conductors, occurring as the transformer is loaded, increases the stress. Conversely, magnetic losses in the core and tie plate expansion contribute to a reduction in stress. This paper presents the effect of step changes in core losses and copper losses by on-line measurements of the clamping pressure, to better understand the mechanical stresses acting upon the solid insulation cellulose materials. Energisation is found to decrease the clamping pressure following warming up of the transformer, and loading the transformer increased the pressure as the windings increased in temperature. The converse effect was found when unloading and de-energising. The on-line monitoring system provides a new and important step towards ensuring the short-circuit performance of power transformers.
1 August 2019 in IEEE Transactions on Dielectrics and Electrical Insulation
It is experienced that MV XLPE cable links including heat shrink cable joints can have a high electrical conductivity compared to the XLPE cable insulation. The field grading sleeve included in the joint design is proposed to be responsible for the reduced insulation resistance and is therefore studied in this paper. New field grading sleeves are aged in the laboratory at temperatures up to 150 °C in both dry and humid conditions. The degree of ageing is determined by DSC measurements, the mechanical properties are determined by tensile strength testing, and the electric properties are characterized by time domain dielectric response measurements. The results show that after only a few days above the melting point of 104 °C the tensile strength of the material is strongly reduced. The electrical conductivity is strongly dependent on the degree of thermal ageing of the sleeve material but also the water content. The combination of significant thermal degradation and a high water content results in particularly high conductivity values. It is shown that the increase of the conductivity after ageing at 150 °C for 15 days is five orders of magnitude for wetted field grading sleeves measured at 30 °C.