The objective of this study was to demonstrate the potential utilization of fly ash (FA), wood ash (WA), and metakaolin (MK) in developing new alkali-activated materials (AAMs) for the removal of cadmium ions from waste water. The synthesis of AAMs involved the dissolution of solid precursors, FA, WA, and MK, by a liquid activator (Na₂SiO₃ and NaOH). In concentrated solutions of the activator, the formation of an aluminosilicate gel structure occurred. DRIFT spectroscopy of the AAMs indicated main vibration bands between 1036 cm⁻¹ and 996 cm⁻¹, corresponding to Si-O-Si/Si-O-Al bands. Shifting vibration bands were seen at 1028 cm⁻¹ to 1021 cm⁻¹, indicating that the Si-O-Si/Si-O-Al bond is elongating, and the bond angle is decreasing. Based on the X-ray diffraction results, alkali-activated samples consist of an amorphous phase and residual mineral phases. The characteristic “hump” of an amorphous phase in the range from 20 to 40° 2θ was observed in FA and in all AWAFA samples. By the XRD patterns of the AAMs obtained by the activation of a solid three-component system, a new crystalline phase, gehlenite, was identified. The efficiency of AAMs in removing cadmium ions from aqueous solutions was tested under various conditions. The highest values of adsorption capacity, 64.76 mg/g (AWAFA₆), 67.02 mg/g (AWAFAMK₆), and 72.84 mg/g mg/g (AWAMK₆), were obtained for materials activated with a 6 M NaOH solution in the alkali activator. The Langmuir adsorption isotherm and pseudo-second kinetic order provided the best fit for all investigated AAMs.

The occurrence and distribution of yttrium and rare earth elements (REYs), along with major elements and heavy metal(loid)s (HMs) in coal fly ash (CFA) from five coal-fired power plants (CFPPs), were analyzed, and the REY-associated ecological and health risks were assessed. The individual REYs in CFA were abundant in the following order: Ce > La > Nd > Y > Pr > Gd > Sm > Dy > Er > Yb > Eu > Ho > Tb > Tm > Lu. The total REY content ranged from 135 to 362 mg/kg, averaging 302 mg/kg. The mean light-to-heavy REY ratio was 4.1, indicating prevalent light REY enrichment in CFA. Significantly positive correlations between the REYs suggested that they coexist and share similar origins in CFA. REYs were estimated to pose low to moderate ecological risks, with risk index (RI) values ranging from 66 to 245. The hazard index (HI) and target cancer risk (TCR) of REYs from CFA, estimated to be higher for children (HIc = 0.15, TCRc = 8.4 × 10⁻¹⁶) than for adults (HIa = 0.017, TCRa = 3.6 × 10⁻¹⁶), were well below the safety limits (HI = 1, TCR = 1.0 × 10⁻⁶). However, the danger to human health posed by HMs in the same CFA samples (HIc = 5.74, TCRc = 2.6 × 10⁻⁴, TCRa = 1.1 × 10⁻⁴) exceeded the safe thresholds (excl. HIa = 0.63). The mean RI and HI attributed to REYs in CFA were 14% and 2.6%, respectively, of the total risks that include HMs.

The aim of the presented research was to investigate the application possibility of wood ash and metakaolin to obtain alkali-activated materials as relatively new materials in the building industry. Thus, in order to assess the adequate use of these waste materials, structural and radiological characteristics should be considered. Until now, the focus has been on ash from thermal power plants produced by burning coal, but a large part of households in our country have individual fireplaces in which wood is used as the basic raw material; thus, it is very interesting to measure the activity concentration of radionuclide in wood ash as well as the possibility of reusing that ash for other purposes. All materials were studied, in terms of physical and chemical characteristics, by methods such as X-ray diffraction (XRD), Fourier transform infra-red (FTIR) spectroscopy, and scanning electron microscopy and energy-dispersive X-ray spectroscopy (SEM/EDS). XRD measurements of wood ash samples showed that it consists of calcite and larnite. FTIR spectroscopy revealed a polymeric Si–O–Al framework in alkali-activated materials and Si–O bonding bands corresponding to silicon dioxide. Determination of radionuclide content was performed by means of gamma-ray spectrometry. Results showed that the alkaline activation process led to the decrease in the activity concentration of radionuclides detected in the measured samples. External radiation hazard index (H_ex) for wood ash was reduced by more than 50% after alkali activation. The results of activity concentration measurements in alkali-activated materials indicate potential for their safe application in building construction.

Due to industrial growth and its impact on the environment, the increasing amount of industrial waste requires a comprehensive approach aligned with the principles of sustainable development. The main goals are not only to preserve natural resources but also to encourage innovation in the reuse of waste materials. In an attempt to reduce the problems regarding waste disposal and wastewater treatment in the textile industry, fibrous textile waste was used as a starting material to obtain carbon adsorbents for the removal of pollutants from wastewater. Waste cotton and mixed yarns, mainly consisting of polysaccharide cellulose, were hydrothermally carbonized and activated with KOH to convert them into efficient carbon adsorbents for heavy metal removal from water. Characterization of carbonized material showed that after activation, an increase in specific surface area (up to 872 m²/g) and content of surface oxygen groups (6.04 mmol/g) leads to a higher affinity towards heavy metal ions, especially lead ions, and high adsorption capacity of 19.98 mg/g obtained for activated cotton yarns. The results of this research represent a contribution to the reduction of waste materials by modifying them into adsorbents, while the regeneration of adsorbents is an example of the practical application of polysaccharide-based materials in the purification of wastewater containing various heavy metal ions.

Waste hemp and flax fibers, and cotton and cotton/polyester yarns, available in large quantities from the textile industry, were used as cheap and effective sorbents for the removal of methylene blue from wastewater. Waste fibers and yarns were characterized by scanning electron microscopy, Fourier transform infrared spectroscopy, iodine sorption, water retention, and point of zero charge, as well as through the determination of crystallinity index and degree of surface crystallinity. The adsorption of methylene blue was optimized by examining the influence of contact time, initial concentration, temperature, and pH value. It was found that the more ordered structure of cotton and cotton/polyester yarns leads to lower adsorption capacities and better agreement with pseudo-second order kinetic and Langmuir isotherm model, while the more heterogeneous structure of flax and hemp fibers shows higher capacities for methylene blue adsorption, better described by the pseudo-first order kinetic and Freundlich isotherm model. Based on the obtained results, waste lignocellulosic fibers and yarns can be used for the discoloration of wastewater, thereby solving the problem of waste generated in the textile industry.