The influence of friction stir processing parameters and the subsequent evolution of microstructures and corrosion behaviour of Al–SiC surface composites fabricated in the presence of graphitic flakes are presented in this paper. The circumferential shear stress exerted by the rotating tool exfoliates the graphite flakes into few-layered graphene during processing. These graphene flakes preferentially occupy both the grain boundaries and the SiC–Al interface during recrystallization. The potentiodynamic polarization test, in 3.5 wt% sodium chloride (NaCl) solution, is conducted for samples processed at various tool rotational speeds and it is found that the presence of this thin graphitic layer at these locations reduces the intergranular and interfacial corrosion to a great extent. The tool rotational speed has a significant influence on processing, and samples fabricated at an optimum tool rotational speed of 2200 rpm shows better corrosion resistance and mechanical properties as compared to that at lower and higher speeds. Raman spectroscopic analysis, X-ray diffraction studies and microhardness tests corroborate the experimental results and the proposed mechanisms.
This study details the mechanical incorporation of graphite particles into the surface of aluminium (Al-1100) to fabricate surface composites using an electrical resistance heating-assisted pressing method. Initially, the aluminium surface is coated with graphite via solution casting. Incorporation is accomplished by locally heating the graphite–aluminium interface with electrical resistance heating and subsequent mechanical pressure application. The magnitude of softening of the aluminium surface can be regulated by process considerations such as the applied current and heating duration. Microstructural assessment of the aluminium–graphite composite was conducted using SEM, TEM, Raman spectroscopy, and XRD. The surface mechanical properties and reduced Young’s modulus were improved by more than 200% and 150%, respectively. A detailed tribological study was conducted, and the study suggested that the wear resistance and COF improved by more than 50%. The progress in wear resistance and COF is corroborated by the microstructural changes in the matrix suggested by the Raman spectroscopy and XRD results.