Relativistic electrons generated by the interaction of petawatt-class short laser pulses with solid targets can be used to generate bright x-rays via bremsstrahlung. The efficiency of laser energy transfer into these electrons depends on multiple parameters including the focused intensity and pre-plasma level. This paper reports experimental results from the interaction of a high intensity petawatt-class glass laser pulses with solid targets at a maximum intensity of 10 ¹⁹ W cm ⁻² . In-situ measurements of specularly reflected light are used to provide an upper bound of laser absorption and to characterize focused laser intensity, the pre-plasma level and the generation mechanism of second harmonic light. The measured spectrum of electrons and bremsstrahlung radiation provide information about the efficiency of laser energy transfer.

The magnetic quadrupole structure formation during the interaction of two ultrashort high power laser pulses with a collisionless plasma is demonstrated with 2.5-dimensional particle-in-cell simulations. The subsequent expansion of the quadrupole is accompanied by magnetic-field annihilation in the ultrarelativistic regime, when the magnetic field cannot be sustained by the plasma current. This results in a dominant contribution of the displacement current exciting a strong large scale electric field. This field leads to the conversion of magnetic energy into kinetic energy of accelerated electrons inside the thin current sheet.

This paper describes design, development, and implementation of a multi-channel magnetic electron spectrometer for the application in laser–plasma interaction experiments carried out at the Prague Asterix Laser System. Modular design of the spectrometer allows the setup in variable configurations to evaluate the angular distribution of hot electron emission. The angular array configuration of the electron spectrometers consists of 16 channels mounted around the target. The modules incorporate a plastic electron collimator designed to suppress the secondary radiation by absorbing the wide angle scattered electrons and photons inside the collimator. The compact model of the spectrometer measures electron energies in the range from 50 keV to 1.5MeV using ferrite magnets and from 250 keV to 5MeV using stronger neodymium magnets. An extended model of the spectrometer increases the measured energy range up to 21MeV or 35MeV using ferrite or neodymium magnets, respectively. Position to energy calibration was obtained using the particle tracking simulations. The experimental results show the measured angularly resolved electron energy distribution functions from interaction with solid targets. The angular distribution of hot electron temperature, the total flux, and the maximum electron energy show a directional dependence. The measured values of these quantities increase toward the target normal. For a copper target, the average amount of measured electron flux is 1.36 × 10¹¹, which corresponds to the total charge of about 21 nC.

The interaction of high-power laser pulses with undercritical foams produced by different techniques but with the same average density is studied at the PALS laser facility. The spatial–temporal evolution of X-ray emission is observed using an X-ray streak camera, electron and ion temperatures are measured by X-ray spectroscopy, and hot-electron production is characterized by monochromatic X-ray imaging. Transmission of a femtosecond laser probe pulse through foams is observed in the near and far fields. In spite of large differences in pore size and foam structure, the velocity of ionization front propagation is quite similar for all the foams studied and is slower than that in a homogeneous material of the same average density. The ion temperature in the plasma behind the ionization front is a few times higher than the electron temperature. Hot-electron production in plastic foams with small pores is strongly suppressed compared with that in solid targets, whereas in foams produced by additive manufacturing, it is significantly increased to the level observed in bare copper foil targets.

This paper presents experimental investigation of temperature scaling and threshold of instability in hot electron and bremsstrahlung radiation from the interaction of sub-nanosecond and kilo-joule class laser pulses with a tantalum foil target at Prague Asterix Laser System. The laser intensity was varied between 4 × 10 15 and 3 × 10 16 W · cm⁻² at the target focus. The energy distribution functions of electrons were measured by an angular array of magnetic spectrometers indicating the electron temperature in the range between 30 keV and 70 keV. The bremsstrahlung spectrum was characterized using a scintillator-based calorimeter. In particular, we show the laser-energy scaling of the total flux of hot electrons in the forward and backward directions with respect to the laser vector, the conversion efficiency of the laser energy to the energy carried by hot electrons, and the temperature of hot electrons as well as the unfolded bremsstrahlung temperature using a Monte Carlo code consistent with signals of the scintillator detector. The scaling shows that the electron flux increases discontinuously with increasing laser intensity from ∼ 1 − 2 × 10 16 W · cm⁻² with consequent instability in the production of hot electrons and bremsstrahlung radiation.