Most high-mountain regions worldwide are susceptible to snow avalanches during the winter or all year round. In this study, a Universal Snow Avalanche Modeling Index is developed, suitable for determining avalanche hazard in mountain regions. The first step in the research is the collection of data in the field and their processing in geographic information systems and remote sensing. In the period 2023–2024, avalanches were mapped in the field, and later, avalanches as points in geographic information systems (GIS) were overlapped with the dominant natural conditions in the study area. The second step involves determining the main criteria (snow cover, terrain slope, and land use) and evaluating the values to obtain the Snow Avalanche Formation Index (SAFI). Thresholds obtained through field research and the formation of avalanche inventory were used to develop the SAFI index. The index is applied with the aim of identifying locations susceptible to avalanche formation (source areas). The values used for the calculation include Normalized Difference Snow Index (NDSI > 0.6), terrain slope (20–60°) and land use (pastures, meadows). The third step presents the analysis of SAFI locations with meteorological conditions (winter precipitation and winter air temperature). The fourth step is the modeling of the propagation (simulation) of other parts of the snow avalanche in the Flow-R software 2.0. The results show that 282.9 km2 of the study area (Šar Mountains, Serbia) is susceptible to snow avalanches, with the thickness of the potentially triggered layer being 50 cm. With a 5 m thick snowpack, 299.9 km2 would be susceptible. The validation using the ROC-AUC method confirms a very high predictive power (0.94). The SAFI–Flow-R approach offers snow avalanche modeling for which no avalanche inventory is available, representing an advance for all mountain areas where historical data do not exist. The results of the study can be used for land use planning, zoning vulnerable areas, and adopting adequate environmental protection measures.
The University of Belgrade, Faculty of Mining and Geology has been involved in landslide risk reduction activities at the national, regional, and site-specific levels in Serbia for decades. Since 2011 the Faculty has had several activities closely connected with the International Consortium on Landslides, including the International Programme on Landslides Projects 181, 210 and 248, as well as World Centre of Excellency (WCoE) from 2017. In the past decade the Faculty of Mining and Geology was involved in several national, regional and local projects funded by the People of Japan, UNDP and The World Bank on landslide risk reduction in Serbia, Bosnia and Herzegovina and North Macedonia. They all closely involved many stakeholders from national to local authorities including Ministries, Local Self Governments, Public Enterprises, Emergency Offices and Civil Protection units. In this report, the activities of WCoE for national and local authorities on landslide risk reduction will be presented.
Flow-type landslides are not typical in this region of the Balkans. However, after the Tamara cyclone event in 2014, numerous such occurrences have been observed in Serbia. This paper presents the initial results of a detailed investigation into debris flows in Serbia, comparing findings from two programs: RAMMS DBF and Geoflow SPH. Located in Western Serbia, the Selanac debris flow is a complex event characterized by significant depths in the initial block and entrainment zone. Previous field investigations utilized ERT surveys, supplemented by laboratory tests, to characterize material behavior. Approximately 450,000 m3 of material began to flow following an extreme precipitation period, ultimately traveling 1.2 km to the deposition zone. For validation purposes, ERT profiles from both the deposition zone and the source area were utilized, with particular attention given to areas where entrainment was substantial, as this had a significant impact on the final models. The first objective of this research is to conduct a detailed investigation of debris flow using field investigations: geophysical (ERT) and aerial photogrammetry. The second objective is to evaluate the capacity of two debris flow propagation models to simulate the reality of these phenomena. The GeoFlow-SPH code overestimated the maximum propagation thickness in comparison to the RAMMS model. The numerical results regarding final depths closely align, especially when considering the estimated average depth in the deposition zone. The results confirm the necessity of using multiple simulation codes to more accurately predict specific events.