Tina Đurić

Mrs. Tina Đurić

orcid

Research Focus & Metrics

Academic Career Length

5Years (2022-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
8 October 2024 in Applied Sciences
Verified
Journal Article
Open access
PDF file
JKJelka Krusic
Jelka Krusic
Juan Manuel PastorJuan Manuel Pastor
Juan Manuel Pastor
Saeid Moussavi TayyebiSaeid Moussavi Tayyebi
Saeid Moussavi Tayyebi
DĐDragana Đurić
Dragana Đurić
TĐTina Đurić
Tina Đurić
BABiljana Abolmasov
Biljana Abolmasov
Flow-type landslides are not typical in this region of the Balkans. However, after the Tamara cyclone event in 2014, numerous such occurrences have been observed in Serbia. This paper presents the initial results of a detailed investigation into debris flows in Serbia, comparing findings from two programs: RAMMS DBF and Geoflow SPH. Located in Western Serbia, the Selanac debris flow is a complex event characterized by significant depths in the initial block and entrainment zone. Previous field investigations utilized ERT surveys, supplemented by laboratory tests, to characterize material behavior. Approximately 450,000 m3 of material began to flow following an extreme precipitation period, ultimately traveling 1.2 km to the deposition zone. For validation purposes, ERT profiles from both the deposition zone and the source area were utilized, with particular attention given to areas where entrainment was substantial, as this had a significant impact on the final models. The first objective of this research is to conduct a detailed investigation of debris flow using field investigations: geophysical (ERT) and aerial photogrammetry. The second objective is to evaluate the capacity of two debris flow propagation models to simulate the reality of these phenomena. The GeoFlow-SPH code overestimated the maximum propagation thickness in comparison to the RAMMS model. The numerical results regarding final depths closely align, especially when considering the estimated average depth in the deposition zone. The results confirm the necessity of using multiple simulation codes to more accurately predict specific events.

10 November 2024 in Applied Sciences
Verified
Journal Article
Open access
PDF file
SĆStevan Ćorluka
Stevan Ćorluka
DRDragoslav Rakić
Dragoslav Rakić
NZNikola Zivanovic
Nikola Zivanovic
KDKsenija Djokovic
Ksenija Djokovic
TĐTina Đurić
Tina Đurić
One of the prerequisites for the safe exploitation of surface mines is the stability of the working and final slopes of the mine. In order to ensure this, it is necessary to carry out detailed field and laboratory geomechanical tests of the soil and, based on the obtained results, make calculations related to stability analyses. The results obtained in this way are used for dimensioning the slope of exploitation slopes (excavation). Landslides occur when the ultimate shear strength is reached, and therefore, the adequate definition of shear strength parameters is one of the essential prerequisites for successfully solving the stability problem. Unlike earlier tests in Serbia, when the residual shear strength parameters were determined based on the usual conventional methods (direct shear apparatus, triaxial apparatus), this time, in addition to the direct shear apparatus, a ring shear apparatus was also chosen for testing. The paper shows the method of determining the residual shear strength parameters of high plasticity gray clays and siltstones of roof sediments from open pit mine Drmno, using direct and ring shear apparatus. The results show that the residual angle of internal friction for gray clays obtained with the ring shear apparatus is 9.9–10.8°, and for the siltstone, it is 11.8–12.9°, both of which are lower than the values obtained with the direct shear apparatus. In addition, correlations between the residual parameters of soil shear resistance and some physical indicators (plasticity index, clay content) are provided, showing high correlation coefficients. The proposed correlations should be used only when time and financial constraints prevent the execution of actual tests to determine residual shear strength, as concrete experimental procedures provide a much more reliable assessment of the residual strength properties of the soil.

1 January 2025
Verified
Conference Paper
Closed access
SFSrbija Univerzitet U Beogradu – Rudarsko-Geološki Fakultet
Srbija Univerzitet U Beogradu – Rudarsko-Geološki Fakultet
TĐTina Đurić
Tina Đurić
DRDragoslav Rakić
Dragoslav Rakić
JPJovana Janković Pantić
Jovana Janković Pantić
IIIrena Basarić Ikodinović
Irena Basarić Ikodinović
MMMarija Milosavljević
Marija Milosavljević
Empirical correlations commonly used in geotechnical practice can serve as a valuable tool for estimating the required parameters during the design phase and execution of geotechnical analyses. One of the increasingly important parameters in geotechnical analysis is the undrained shear strength of soil, whose use is also recommended by Eurocode 7 standards, especially when examining the properties of fine-grained soils. Variations in water content significantly influence the consistency state of the soil and have a substantial impact on its behaviour, particularly on shear strength. This study presents correlations between undrained shear strength (cu), determined using the fall cone method, and water content. The results showed a high level of correlation between undrained shear strength and water content, confirming a logarithmic relationship. Empirical equations were applied to enable more accurate estimation of undrained shear strength, with a high coefficient of determination (R²).

30 September 2026 in Proceedings of the Bulgarian Academy of Sciences
Verified
Journal Article
Open access
PDF file
TĐTina Đurić
Tina Đurić
DRDragoslav Rakić
Dragoslav Rakić
JPJovana Janković Pantić
Jovana Janković Pantić
JLJelka Lukić
Jelka Lukić
SĆStevan Ćorluka
Stevan Ćorluka
Typical empirical correlations in geotechnical practice can be useful for estimating the values of necessary parameters to be used in design and geotechnical calculations. For fine-grained soils, undrained shear strength is a key parameter recommended by Eurocode 7 and is strongly influenced by water content. This paper investigates the relationship between water content, fall cone penetration, and undrained shear strength of medium-plasticity silty clays based on an extensive laboratory dataset obtained over a wide range of moisture conditions, including values both below and above natural water content. The analysis is conducted on remoulded soil samples. Power-law relationships between water content and cone penetration were established, and the corresponding parameters were evaluated and compared with values reported in the literature. The undrained shear strength-water content relationship was further analyzed using normalized expressions based on the water content ratio, enabling direct comparison with existing empirical models. A within-sample regression approach was applied to account for repeated measurements on individual soil samples, revealing consistently high coefficients of determination and a narrow range of regression slopes across materials. The results demonstrate that systematic laboratory testing combined with appropriate data normalization and within-sample analysis provides physically meaningful and robust empirical relationships. A site-specific empirical model for estimating undrained shear strength is proposed, offering improved reliability compared to generalized correlations and supporting more accurate site-specific geotechnical assessments.

1 January 2025
Verified
Conference Paper
Closed access
MMMarija Milosavljević
Marija Milosavljević
DRDragoslav Rakić
Dragoslav Rakić
TĐTina Đurić
Tina Đurić
IAIvan Arsić
Ivan Arsić
NSNemanja Stanić
Nemanja Stanić
A sanitary landfill is a complex geotechnical structure for safe and environmentally sound disposal of municipal waste. To prevent environmental contamination, especially of groundwater, design solutions must ensure high impermeability, stability, and long-term protection. The landfill base is protected with a double-layer composite lining and a leachate collection system, while cover layers prevent erosion and infiltration. This study presents the „Gigoš“ Regional Sanitary Landfill in Jagodina as an example of modern landfill design. Special emphasis is placed on geosynthetic materials in lining layers for efficient impermeability and minimal environmental impact. Using project documentation and field data, the landfill layers, their functions, and their role in long-term environmental protection are analyzed.

28 January 2022 in Proceedings of the Bulgarian Academy of Sciences
Verified
Journal Article
Closed access
PDF file
JPJovana Janković Pantić
Jovana Janković Pantić
DRDragoslav Rakić
Dragoslav Rakić
IIIrena Basaric Ikodinovic
Irena Basaric Ikodinovic
TĐTina Đurić
Tina Đurić
GHGordana Hadzi-Nikovic
Gordana Hadzi-Nikovic
Disposal of waste in municipal solid waste landfills is the only way of waste disposal in Serbia, with daily compaction and covering with soil material. Due to less space for the construction of new landfills, it is necessary to use their maximum capacity. Well-compacted municipal solid waste takes up less volume and enables safer storage, so it is useful to previously determine the compaction parameters in the laboratory: maximum dry unit weight (γdmax) and optimal water content (wopt). In the practice so far, the standard method has been used to obtain these parameters (Proctor compaction test) which is common in soil mechanics. However, although this methodology has been adopted, different treatments of municipal solid waste at the landfill (including pre-treatment) indicate the need to change this classical approach. Therefore, during the research, various innovative solutions are introduced, such as the change of the classic flat Proctor hammer, by adding spikes, whose function, in addition to compaction, is partial destruction and shredding of municipal waste. In this way, the operation of compactors (hedgehogs) in the field is simulated. The paper presents the behaviour of four artificially prepared samples of municipal solid waste of different composition. The samples were tested in the standard Proctor apparatus at the same compaction energy, using different hammers, a standard flat hammer, and an innovative hammer with spikes. After that, the geotechnical effects of compaction depending on the applied approach were analyzed.