The fabrication process of pretensioned prestressed concrete (PC) girders involves temperature changes, which affect the effective prestress and mechanical properties of the girders. Currently, there is a lack of a holistic understanding and accurate calculation methods for the prestress variation due to temperature change (PVTC), leading to technical challenges in calculating effective prestress in pretensioned PC girders. This study investigates the PVTC in three stages considering the time-varying interaction between concrete and tendons, proposes a new method to consider the effect of a deviator on the PVTC of a bent tendon, conducts an experimental study to validate the theoretical analysis, and develops measures for reducing the PVTC. The results show that the presented method provides reasonable predictions of PVTC, and the PVTC of the girder with steam curing is up to 80.3 MPa. Based on the presented method, measures for reducing the PVTC are proposed. This study provides new insights into computing the PVTC and improves the design and fabrication of pretensioned PC girders.
This paper investigates the interfacial bonding behavior between high toughness resin concrete with steel wire mesh (HTRCS) and concrete. A total of five sets of fifteen double shear specimens were tested for parameters including concrete strength and material properties of HTRCS composites. The test results showed that the failure mode of DS1 specimens was partial debonding and fracture, and the rest of the specimens were the fracture of HTRCS. The concrete strength and reinforcement ratios of HTRCS composites were positively correlated with interfacial adhesion properties. When the concrete strength was increased from C30 to C40 and C50, the ultimate load increased by 43.4% and 43.2%, respectively. The ultimate load capacity increased by 32.1%, with the reinforcement ratio of HTRCS composites increasing from 1.05% to 1.83%. Moreover, the bonding slip model and the bearing capacity formula for the interface between HTRCS composites and concrete were proposed, and the calculation values were in good agreement with the test values, with an average value of 0.978.
High-toughness resin concrete steel mesh (HTRCS) composites, as a novel reinforcement material, are extensively employed, yet there has been a lack of comprehensive quantitative studies on them, and our knowledge about them predominantly relies on experimental investigations. To delve into the shear performance of reinforced concrete beams fortified with HTRCS, this research executed four-point bending static load experiments on a benchmark of two standard beams and six HTRCS-reinforced beams. The results demonstrate that the shear bearing capacity of the reinforced concrete beams was notably enhanced with HTRCS, ranging from approximately 10% to 65%. Further examination revealed that the stiffness of the specimens is significantly influenced by the HTRCS thickness, shear–span ratio, and concrete strength, with the shear–span ratio exerting the most notable impact on stiffness. This analysis furnishes a solid theoretical foundation for the utilization of HTRCS.