The equalization technique is a key technique in the secondary utilization of retired batteries. In this paper, a double-layer equalization method is proposed, which combines the reconfigurable topology with the converter active equalization method. The inner layer uses the reconfigurable topology to have a balanced set of battery cells. Thanks to isolating the lowest SOC (state of charge) cell in the battery group, the energy transfer loss among cells is avoided. In addition, this topology can reduce cost and control complexity and the number of components. In the outer layer, a Buck–Boost converter is added for each battery group, and the outputs of the converters are connected in series. The output voltage of the converter varies as the SOC of the group varies while the total output voltage is stable. In order to validate the proposed method, an equalization circuit consisting of 12 battery cells is built on Matlab/Simulink. Simulation results show that the proposed method can effectively balance the battery pack and maintain a stable output voltage. Compared to the conventional active equalization method, the proposed method has significantly improved the equalization efficiency.
With the application of lithium batteries more and more widely, in order to accurately estimate the state of charge (SoC) of the battery, this paper uses the iterated extended Kalman filter (IEKF) algorithm to estimate the SoC. The Levenberg–Marquardt (LM) method is used to optimize the error covariance matrix of IKEF. Based on the hybrid pulse power characteristics experiment, a second-order Thevenin model with variable parameters is established on the MATLAB platform. The experimental results show that the proposed model is effective under the constant current discharge condition, the Federal Urban Driving Schedule (FUDS) condition, and the Beijing dynamic stress test (BJDST) condition. The results show that the simulation error of the improved LM-IEKF algorithm is less than 2% under different working conditions, which is lower than that of the IKEF algorithm. The improved algorithm has a fast convergence speed to the true value, and it has a good estimation accuracy in the case of large changes in external input current. Additionally, the fluctuation of error is relatively stable, which proves the reliability of the algorithm.
Solar generation has become increasingly important in grid applications. In order to improve the energy efficiency of the photovoltaic array (PV), factors such as temperature, nonlinear characteristics, and partial shadow conditions (PSCs) of the PV must be fully considered. An excellent maximum power point tracking (MPPT) control strategy can effectively improve the energy utilization efficiency of photovoltaic cells and provide strong support for the construction of smart campuses in terms of environmental protection and energy saving. A traditional method such as Perturb & Observe (P&O) and incremental conductance (INC) will fall into the local maximum power point (LMPP). In the past decade, researchers have proposed many MPPT methods to solve the difficulties of the PV system. However, they have failed to fully consider dynamic changes in irradiance conditions. Changes in the irradiance of photovoltaic arrays can lead to an extension of the convergence time and an increase in the oscillation amplitude. Many current MPPT methods have shortcomings such as requiring a long convergence time, large oscillation amplitude, and being prone to falling into LMPP. In order to reduce the oscillation amplitude and improve the convergence speed, a novel Multi-strategy Improved Tuna Swarm Optimization hybrid INC (ITSO-INC) method is introduced in this article. This strategy involves improving the Tuna Swarm Optimization (TSO) through Levy Flight and a linear weight coefficient. In addition, the INC method is added in the later stage to improve the accuracy of MPPT tracking. The proposed algorithm can extract the global maximum power point under different partial shading. In order to verify the effectiveness of the proposed method, the proposed method was compared with other metaheuristic algorithms such as Cuckoo Search (CS) and TSO. The proposed ITSO-INC technique was tested over four different patterns of partial shading conditions. Modulation was performed by tracking the sudden change in the shadow pattern of the MPP. These simulation results confirm that the proposed method has fast convergence, high accuracy, zero steady state oscillation, and a rapid response to dynamic change.
We present herein a novel method of bipolar field-effect control on DC electroosmosis (DCEO) from a physical point of view, in the context of an intelligent and robust operation tool for stratified laminar streams in microscale systems. In this unique design of the DC flow field-effect-transistor (DC-FFET), a pair of face-to-face external gate terminals are imposed with opposite gate-voltage polarities. Diffuse-charge dynamics induces heteropolar Debye screening charge within the diffuse double layer adjacent to the face-to-face oppositely-polarized gates, respectively. A background electric field is applied across the source-drain terminal and forces the face-to-face counterionic charge of reversed polarities into induced-charge electroosmotic (ICEO) vortex flow in the lateral direction. The chaotic turbulence of the transverse ICEO whirlpool interacts actively with the conventional plug flow of DCEO, giving rise to twisted streamlines for simultaneous DCEO pumping and ICEO mixing of fluid samples along the channel length direction. A mathematical model in thin-layer approximation and the low-voltage limit is subsequently established to test the feasibility of the bipolar DC-FFET configuration in electrokinetic manipulation of fluids at the micrometer dimension. According to our simulation analysis, an integrated device design with two sets of side-by-side, but upside-down gate electrode pair exhibits outstanding performance in electroconvective pumping and mixing even without any externally-applied pressure difference. Moreover, a paradigm of a microdevice for fully electrokinetics-driven analyte treatment is established with an array of reversed bipolar gate-terminal pairs arranged on top of the dielectric membrane along the channel length direction, from which we can obtain almost a perfect liquid mixture by using a smaller magnitude of gate voltages for causing less detrimental effects at a small Dukhin number. Sustained by theoretical analysis, our physical demonstration on bipolar field-effect flow control for the microfluidic device of dual functionalities in simultaneous electroconvective pumping and mixing holds great potential in the development of fully-automated liquid-phase actuators in modern microfluidic systems.
We propose herein a novel microfluidic approach for the simultaneous active pumping and mixing of analytes in a straight microchannel via the AC field-effect control of induced-charge electro-osmosis (ICEO) around metal–dielectric solid Janus cylinders of inherent inhomogeneous electrical polarizability immersed in an electrolyte solution. We coin the term “Janus AC flow field-effect transistor (Janus AC-FFET)” to describe this interesting physical phenomenon. The proposed technique utilizes a simple device geometry, in which one or a series of Janus microcylinders are arranged in parallel along the centerline of the channel’s bottom surface, embedding a pair of 3D sidewall driving electrodes. By combining symmetry breaking in both surface polarizability and the AC powering scheme, it is possible, on demand, to adjust the degree of asymmetry of the ICEO flow profile in two orthogonal directions, which includes the horizontal pump and transversal rotating motion. A comprehensive mathematical model was developed under the Debye–Hückel limit to elucidate the physical mechanism underlying the field-effect-reconfigurable diffuse-charge dynamics on both the dielectric and the metal-phase surfaces of the Janus micropillar. For innovation in applied science, an advanced microdevice design integrating an array of discrete Janus cylinders subjected to two oppositely polarized gate terminals is recommended for constructing an active microfluidic pump and mixer, even without external moving parts. Supported by a simulation analysis, our physical demonstration of Janus AC-FFET provides a brand-new approach to muti-directional electro-convective manipulation in modern microfluidic systems.
In target detection, tracking, and recognition tasks, high-quality images can achieve better results. However, in actual scenarios, the visual effects and data quality of images are greatly reduced due to the influence of environmental factors, which affect subsequent detection, recognition, and other tasks. Therefore, this paper proposes an image rain removal algorithm based on multi-scale features, which can effectively remove rain streaks. First of all, this paper proposes a deraining algorithm that combines spatial information to improve the network’s generalization ability on real images, aiming at the problem of synthetic datasets used by previous deraining algorithms. Then, by proposing a multi-scale rain removal algorithm, it improves the feature extraction capabilities of existing deraining algorithms. Before extracting deep rain features, a preliminary fusion of multi-scale shallow features can be performed, which can show better performance in images of different sizes. In addition, a spatial attention module and channel are introduced. The attention module increases the ability to extract rain information at each scale; the resulting multi-scale feature image rain removal algorithm is called MFD. Finally, the rain removal algorithm is validated on the rain removal dataset, and the proposed method can effectively remove rain patterns, provide strong performance improvement on several datasets in the image rain removal task, and provide high-quality images for subsequent detection and recognition tasks.