The interest in minimising fuel consumption and greenhouse gas emissions among road specialists is increasing. Thus, methods for reducing asphalt concrete mixing and compaction temperatures by a few tens of degrees Celsius without compromising the long-term performance has become a topic of significant interest. This study is focused on the analysis of warm mix asphalt (WMA) prepared with locally available materials in order to determine the suitable technology applicable to the specific traffic and climatic conditions of Romania. WMA was prepared using different warm mix additives (organic additives, chemical additive, and synthetic zeolite) at different mixing and compaction temperatures, and bitumen blends with these additives were analysed by carrying out the dynamic shear rheometer test and evaluating the penetration index. In conclusion it was noted that most additives did not lead to a significant change of bitumen’s characteristics, but the organic additive had a big influence on the bitumen’s properties. The characteristics of WMA are very similar to those of HMA. The mixing and compaction temperatures could be reduced by approximately 40 °C when WMA was blended with the additives without compromising the performance of the asphalt mixture, compared to hot mix asphalt.
Within the last decade, much attention has been focused on determining viable techniques for producing sustainable asphalt mixtures and minimizing fuel use and greenhouse gas emissions. Thus, warm mix asphalt (WMA) has become a topic of significant interest among road specialists as it offers a potential solution for reducing the environmental impact of the asphalt mixtures due to the decreased temperatures they require for mixing and compaction compared to hot mix asphalt (HMA). The present study is focused on the Life Cycle Assessment (LCA), according to a “Cradle-to-Gate” approach, of hot mix asphalt and warm mix asphalt prepared with locally available materials and different warm mix additives such as organic additives, chemical additive, and synthetic zeolite. For the analysis of the environmental impact of the warm mix asphalts was used a dedicated software for modeling and evaluating the LCA. The WMA prepared with chemical additive or organic additive led to a decrease of the environmental impact, in the production phase, compared to HMA. The study reveals that the raw materials extraction has the greatest impact on the environment in all studied cases, followed by the actual production phase of the asphalt mixture. For WMA produced with additives there was a decrease in the global impact on the environment compared to HMA.
1 March 2021 in Construction and Building Materials
This study focuses on the investigation of the effect of a reclaimed asphalt material (RAP) and a bio-rejuvenator (mix of vegetable oils) on the stiffness modulus and indirect tensile strength (ITS) values of eight bituminous mixtures produced by using three types of compaction, with different RAP amounts (25% and 50%) and rejuvenator (0%, 0.20%, 0.40% and 0.60% by mass of RAP). A conventional hot mix asphalt was considered as the reference mix. All tests were performed on cylindrical samples produced using: Marshall compaction with 50 blows/side, cored cylindrical specimens from slabs compacted using a roller compactor (39 passes), and, respectively, gyratory compaction on 80 gyrations. Stiffness modulus and ITS values showed strong linear variation with the increase in rejuvenator content, independently of test temperature and type of compaction. The rejuvenating effect of the bio-rejuvenator was observed to counterbalance the impact of RAP. The results at 20 °C for gyratory specimens for the mix with 50% RAP and 0.40% bio-rejuvenator were comparable/closer (under 5% relative difference) to those obtained for the reference mix. A strong correlation between stiffness modulus values of mixes and penetration values of the corresponding binder blends was obtained ().