In this study, high-pressure torsion (HPT) processing is applied to the as-cast Al_0.5CoCrFeNi high-entropy alloy (HEA) for 1, 3, and 5 turns. Microstructural observations reveal a significant refinement of the second phase after HPT processing. This refinement effect is influenced by the number of processing turns and the distance of the processing position from the center. As the number of processing turns or the distance of the processing position from the center increases, the fragmentation effect on the second phase becomes more pronounced. The hardness of the alloy is greatly enhanced after HPT processing, but there is an upper limit to this enhancement. After increasing the number of processing turns to 5, the increase in hardness at the edge becomes less significant, while the overall hardness becomes more uniform. Additionally, the strength of the processed alloy is significantly enhanced, while its ductility undergoes a noticeable decrease. With an increase in the number of processing turns, the second phase is further refined, resulting in improvement of strength and ductility.

High-entropy alloys (HEAs) have garnered significant attention for their exceptional properties, with eutectic high-entropy alloys (EHEAs) emerging as particularly notable due to their incorporation of eutectic structures comprising soft and hard phases. This study investigated the influence of shear strain on the microstructural refinement and mechanical properties of AlCoCrFeNi_2.1 EHEAs, which were subjected to high-pressure torsion (HPT) at room temperature under a pressure of 6 GPa across 0.5 to 3 turns, compared to the initial material. After HPT treatment, significant grain refinement occurred due to strong shear strain, evidenced by the absence of B2 phase peaks in X-ray diffraction (XRD) analysis. Microhardness increased substantially post-HPT, reaching a saturation point at approximately 575 HV after three turns, significantly higher than that of the original sample. Moreover, the ultimate tensile strength of HPT-treated specimens reached around 1900 MPa after three revolutions, compared to approximately 1100 MPa for the as-cast alloy, with a mixed fracture mode maintained. This investigation underscores the efficacy of HPT in enhancing the mechanical properties of AlCoCrFeNi_2.1 EHEAs through microstructural refinement induced by shear deformation, offering insights into the design and optimization of advanced HEAs for various engineering applications.

Cu/Nb multilayer composites with a continuous layered structure were fabricated using accumulative roll bonding (ARB). The effects of Joule heating on the mechanical properties and fracture behavior of these composites under electrically assisted tension (EAT) at different current densities were investigated. It is observed that the ultimate tensile strength (UTS) exhibits a progressive decline with the increasing current density. When the current density reaches 120 A/mm², the UTS decreases by 68.9 MPa, and this decline tends to saturate at high current densities. Furthermore, the elongation (EL) displays significant enhancement at current densities of 40 A/mm² and 80 A/mm², particularly reaching a maximum improvement of 42.1% at 80 A/mm² when compared with room temperature (RT). The fracture mode observed during the EAT process is consistent with that at RT, which remains a ductile fracture.