An all-solution-processed transparent tin oxide (SnO2)-based humidity sensor was directly prepared on borosilicate glass (SnO2–G) and a flexible polyethylene terephthalate (SnO2–PET) substrate without using a template.
The 3D printer and post-curing unit are important factors in producing the best 3D printed crowns. To explore the effects of different combinations of 3D-printers and manufacturer-specified post-curing units on the dimensional accuracy, compressive strength, and degree of conversion (DC%) of 3D-printable resin for fixed dental prostheses. Specimens were designed in 2 sizes and additively-manufactured using 2 digital light processing (DLP) 3D-printers (NextDent 5100, ND and PrintinDLP+, PN). The 3D-printed samples were polymerized using 2 different post curing units (LC-3D Print box, N and PrintInCure+, P). Dimensional accuracy was evaluated under an optical microscope, while compressive strength was determined using a universal testing machine. Fourier transform infrared spectroscopy was used to analyze the resin molecular bond characteristics and DC%. Statistical analysis, including ANOVA and Tukey's HSD post-hoc tests (P < 0.05). Significant dimensional variations were observed for both square and rectangular samples (P < 0.001). The ND-P showed the greatest ductility and relatively high maximum stress. The fracture strengths were ND-N: 181.55 ± 8.37 MPa, ND-P: 151.54 ± 2.06 MPa, PN-N: 175.51 ± 12.44 MPa, and PN-P: 127.84 ± 10.10 MPa (P < 0.001). Surface inspection at 200 × magnification revealed subtler fault lines in ND-N and PN-P. FTIR analyses confirmed DC% was highest for ND-N (79.70 ± 1.02%) and PN-N (78.12 ± 0.94%), intermediate for ND-P (73.24 ± 0.89%) and PN-P (71.06 ± 1.67%). Post-curing units had a greater impact on dimensional accuracy, strength, and polymerization than the choice of 3D-printer. Optimal resin properties require careful optimization of post-curing parameters and equipment.
29 November 2024 in ACS Applied Materials & Interfaces
In this study, Ni-Se intermetallic compound coatings were fabricated using electrodeposition at various process temperatures (40-70 °C). The results show that increasing the process temperature promotes the deposition of Se, which leads to a transition in the crystal phase of the samples from the Ni0.85Se phase, prepared under low-temperature conditions, to a NiSe2 phase. The dissolution rate of Se in pure water from Ni-Se coatings is inversely related to the incorporated Se content, which indicates that the Ni0.85Se phase has a higher natural corrosion rate compared to the NiSe2 phase. Under the influence of an electric field, the corrosion behavior of Ni-Se coatings is dominated by a two-stage reaction involving Se transformation and dissolution. Coatings with a predominant Ni0.85Se phase exhibit more severe corrosion behavior compared to those with a predominant NiSe2 phase, which suggests that the corrosion reaction is enhanced by the electric field. However, because coatings with a predominant NiSe2 phase contain a higher proportion of Se22- ions, the dissolution reaction of SeOx, generated during the electrochemical reaction, is retarded, thereby inhibiting the progression of the corrosion reaction. Consequently, coatings with a predominant NiSe2 phase exhibit relatively better corrosion resistance in a water-based electrolyte.