This study experimentally investigated bridge pier shape effect on the impact force induced by shock wave generated by a dam break, under four different reservoir water depths and dry downstream flow condition. The maximum force, its occurrence time, force intensity, and the impulse were criteria used to evaluate the performance of the bridge piers. Average and wave front celerities were investigated experimentally and numerically and were compared with existing equations in the literature. The time histories of the impact forces were measured using a load cell, and a two-dimensional numerical model was used to determine the shock wave celerities. At a reservoir water depth of 25 cm, the rectangular bridge pier recorded an impact force 2.68 times greater than that of the ogival pier, which had the smallest impact force, and the maximum force occurred 6.23 times earlier than in the case of the upstream facing ogival pier, which recorded the longest time to maximum force. The force intensity for the rectangular pier was approximately 1.8 times higher than that of the ogival bridge pier, which had the lowest force intensity across all studied water depths. It was found that a 2.5-fold increase in reservoir water depth led to an increase in up to 5.51 times the impact force for the rectangular pier.
This experimental study focused on the measurement and analysis of the impact force caused by a tsunami bore on a coastal structure. The bore wave was produced by a dam break mechanism. The water depth in the reservoir and the location of the coastal structures were varied to simulate different impact scenarios. The time history of the force resulting from the impact of the bore wave on the coastal structure was measured. The propagation of the bore wave along the flume was recorded and the video recordings were converted into digital data using an image-processing technique in order to determine the flow depth variations with time. The hydrostatic forces and the corresponding depth and time-averaged hydrodynamic forces as well as the maximum hydrodynamic forces were acquired for each scenario. The ratio of hydrodynamic to hydrostatic forces were obtained, and it was observed that the calculated averaged ratio was within the recommended design ratio. The results indicate that an increase in the reservoir level caused an increase in the magnitude and intensity of the impact forces, however, the relationship was non-linear. Moreover, it was found that the location of the structure did not play a significant role on the intensity of the impact forces.
This study numerically investigated the influence of downstream bed slopes of 0°, 5°, 10°, and 15° and bridge pier positions of 1.1 and 1.3 m on the impact force induced by a tsunami surge wave. Square, circular, and ogival bridge pier geometries were studied to evaluate the influence of geometry. The numerical model used in the study was validated against experimental benchmarks in the literature, and the pressure and impact force time histories were analyzed. The results confirm the suitability of the model for simulating this surge–structure interaction. The results show that the impact forces are significantly influenced by pier geometry. The square geometry recorded a maximum horizontal impact force of 1.73 and 3.32 times more than those for the circular and ogival geometries, respectively. The result further shows that increasing downstream bed slope causes a reduction in the recorded impact forces. The reduction is influenced by the pier geometry, with a maximum reduction of 23% for the square, 32% for the circular, and 38% for the ogival pier recorded as the downstream bed slope increases from 0° to 15°. The circular and ogival pier cases were found to have mitigated flow stagnation and pressure amplification relatively better than the square pier geometry. Slope-dependent reduction factors were proposed for possible incorporation into design guidelines. This study provides practical frameworks for design purposes.