Егор Двоеглазов

Dr. Егор Двоеглазов

orcid

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
Verified
Journal Article
Open access
PDF file
АКАлександр Климов
Александр Климов
BOBaurzhan K. Ospanbekov
Baurzhan K. Ospanbekov
AAAkop Antonyan
Akop Antonyan
VAViktor Anisimov
Viktor Anisimov
ЕДЕгор Двоеглазов
Егор Двоеглазов
YFYury Furletov
Yury Furletov
The wheels of decelerating vehicles in braking mode roll with increased slip, up to complete lock-up, which is a negative phenomenon. This is effectively managed by the anti-lock braking system (ABS). However, in the course of braking, especially before the system activation, self-excited oscillatory processes with high amplitudes may occur, causing increased dynamic loads on the drive system. The paper studies the braking processes of a vehicle with an electromechanical individual traction drive in both electrodynamic regenerative and combined braking modes, utilizing the drive and the primary braking system. The theoretical framework is provided for identifying the self-excited oscillation onset conditions and developing a technique to detect wheel slips during braking to suppress these oscillations. To check the functionality of the wheel-slip observer in braking mode, the performance of the self-excited oscillation pulse suppression algorithm was studied in the MATLAB Simulink 2018b software package. The study results can be used to develop control systems equipped with the function of suppressing self-excited oscillations by vehicle motion.

6 May 2026 in The Russian Automobile and Highway Industry Journal
Verified
Journal Article
Closed access
ЕДЕгор Двоеглазов
Егор Двоеглазов
OKO. A. Kozelkov
O. A. Kozelkov
PDP. K. Dyakov
P. K. Dyakov
Introduction. The reliability of traction electric drive is a key factor determining the operational efficiency of urban electric transport. Bearing assemblies of electric motors remain one of the most common causes of failures leading to vehicle downtime. Materials and methods. A method has been developed for on-board diagnostics of rolling bearing defects in a traction synchronous motor with permanent magnets (SDM) based on the analysis of stator current spectrum (MCSA) with equivalent three-phase current used to normalize diagnostic features. In the study simulation modeling in the MATLAB/Simulink environment was carried out, covering the range of defect angular dimension from 0° to 8° and speeds from 1500 to 8000 rpm. Results. The method proposed sets clear limits to efficiency: the maximum speed for reliable defect detection is 5,000 rpm. At these and lower speeds in the stator current spectrum, a peak is observed of the mechanical rotor speed (fr), the amplitude of which correlates with the defect angular dimension. Normalization by equivalent operating current increases diagnostic accuracy. Discussion and conclusions. The proposed method makes it possible to implement an on-board diagnostic system without installing additional sensors, which is especially important for urban electric buses operating mainly in the range of 2000-5000 rpm. A new method has been developed that integrates normalization by equivalent operating current to quantify the diagnostic sensitivity of the analysis of the stator current spectrum depending on the rotor rotation speed in a permanent magnet synchronous motor and determines the critical speed threshold of 5000 rpm.