S-scheme Fe2O3/g–C3N4 heterojunctions were successfully fabricated by the ultrasonic assistance method to remove norfloxacin (NOR) under visible light irradiation. The synthesized catalysts were well studied through various techniques. The obtained Fe2O3/g–C3N4 heterojunctions exhibited an optimal photocatalytic degradation of 94.7% for NOR, which was 1.67 and 1.28 times higher than using Fe2O3 and g–C3N4 alone, respectively. In addition, the kinetic constant of NOR removal with Fe2O3/g–C3N4 composites was about 0.6631 h−1, and NOR photo-deegradation was still 86.7% after four cycles. The enhanced photocatalytic activity may be mainly attributed to the formation of S-scheme Fe2O3/g–C3N4 heterojunctions with built-in electric fields, which were beneficial to the separation and transfer of photostimulated charge carriers. Furthermore, a possible photo-degradation mechanism of NOR for S-scheme Fe2O3/g–C3N4 heterojunctions is described.
Fe2O3/g-C3N4 nano-heterostructures for photocatalytic degradation of NOR (norfloxacin) were successfully prepared by combining co-precipitation and calcination methods. The g-C3N4, Fe2O3, and different composite ratios of Fe2O3/g-C3N4 (FeCNs) were characterized by XRD, SEM, XPS, UV-vis DRS, PL, and electrochemical tests, and the mechanism of photocatalytic degradation of NOR was analyzed. The results indicated that the semiconductor was attached to the surface of g-C3N4 in the form of α-Fe2O3 crystal with good crystalline structure. The composite of Fe2O3 with g-C3N4 increased the specific surface area of the material, effectively reduced the band gap, strengthened the photogenerated e−/h+ pair separation, and improved the photocatalytic performance of the composite. The photocatalytic degradation of NOR was consistent with the quasi-primary reaction kinetic model. Among them, FeCN-25wt% showed the optimal photocatalytic degradation of NOR (72.3%) with the largest degradation rate (k = 0.00900 min−1). The Fe2O3/g-C3N4 composite structure is inferred to be a Z-type heterojunction.
The presence of polycyclic aromatic hydrocarbons (PAHs) in edible oil has a serious effect on human health and may potentially induce cancer. This study combined thin-layer chromatography and surface-enhanced Raman spectroscopy (TLC-SERS) to rapidly and quantitatively detect PAHs in culinary oil. Machine learning using the principle component analysis-back propagation neural network (PCA-BP) was integrated with TLC-SERS for the detection of PAHs. Ag nanoparticles on diatomite (diatomite/Ag) TLC-SERS substrate were prepared via an in situ growth process and employed as a stationary phase in the TLC channel. The analyte sample was dropped onto the TLC channel for separation and detection. The diatomite/Ag TLC channel demonstrated excellent separation capability and superior SERS performance and successfully detected PAHs from edible oil at a sensitivity of 0.1 ppm. The PCA-BP quantitative analysis model demonstrated outstanding prediction performance. This work demonstrates that the combination of TLC-SERS technology with PCA-BP is an efficient and accurate method for quantitatively detecting PAHs in edible oil, which can effectively improve the quality of food.
1 May 2019 in IOP Conference Series: Earth and Environmental Science
Ni/SiO2-γ-Al2O3 catalyst was prepared by co-impregnation method, study on the performance change of hydrofining product oil, get the optimum process conditions for hydrofining waste oil. The results showed that the hydrogenation effect of waste oil hydrofining was better under the conditions of reaction temperature 250°C, hydrogen pressure 7.9 MPa, space velocity 0.5h−1 and hydrogen oil volume ratio 1000-1200: 1. The bromine value of the oil was 0.18gBr/(100g oil), the residual carbon was 0.012, the sulfur content was 0.37 ug/g, the colorimetric value was less than 0.5, and the freezing point was -37°C, kinematic viscosity had almost no loss, the performance of waste oil after hydrogenation had been greatly improved.
1 May 2019 in IOP Conference Series: Earth and Environmental Science
Sorbitol monooleate (Span80) is an extensively used explosive emulsifier at present. It is a kind of non-ionic surfactant with low molecular weight polyols, which belongs to water-in-oil emulsifier and has good emulsifying performance. The low-quality oleic acid was used as raw material. In order to optimize the synthesis conditions of Span80, the effects of different types of catalyst, reaction time and reaction temperature on the acid value, saponification value and hydroxyl value of Span80 were investigated, and the synthesis conditions of Span80 were optimized. The results showed that 159g sorbitol and 360g oleic acid, with 0.2% Zinc Oxide as catalyst, reacted with 2.5h at 210°C in vacuum, at this time the acid value, saponification value and hydroxyl value of product Span80 were 5.8mgKOH/g, 154.1mgKOH/g and 207.3mgKOH/g, respectively. This method provided a reference for the synthesis of high quality and low cost emulsifiers, and had important significance for civil emulsion explosive enterprises.