In this work, the numerical and experimental analysis on the use of thinned fiber Bragg gratings as refractive index sensors have been carried out. Wet chemical etching in a buffered hydrofluoric acid solution was used for sensor fabrication. Experimental characterization for an almost full etched cladding sensor is presented demonstrating good agreement with numerical results and resolutions of /spl ap/10/sup -5/ and /spl ap/10/sup -4/ for outer refractive index around 1.45 and 1.333, respectively.
In this work, the numerical and experimental investigation of the cladding modes re-organization in high refractive index (HRI) coated Long Period Gratings (LPGs) is reported. Moreover, the effects of the cladding modes re-organization on the sensitivity to the surrounding medium refractive index (SRI) have been outlined. When azimuthally symmetric nano-scale HRI coatings are deposited along LPGs devices, a significant modification of the cladding modes distribution occurs, depending on the layer features (refractive index and thickness) and on the SRI. In particular, if layer parameters are properly chosen, the transition of the lowest order cladding mode into an overlay mode occurs. As a consequence, a cladding modes re-organization can be observed leading to relevant improvements in the SRI sensitivity in terms of wavelength shift and amplitude variations of the LPGs attenuation bands.
1 December 1998 in Composites Science and Technology
In this work, highly sensitive refractive index measurements have been experimentally demonstrated by using thinned fiber Bragg grating (FBG) sensors. When the cladding diameter is reduced, significant changes in the effective refractive index occur due to surrounding medium refractive index modifications, leading to Bragg wavelength shifts. Uniformly thinned FBGs have been obtained by using wet chemical etching in hydrofluoric acid solutions. In order to prove sensor sensitivity, experimental tests have been carried out by using glycerine solutions with well-known refractive indices. Obtained results agree well with the numerical analysis carried out by using the three-layer fiber model. If the cladding layer is completely removed, resolutions of /spl ap/10/sup -5/ and /spl ap/10/sup -4/ for the outer refractive index around 1.450 and 1.333, respectively, are possible. Finally, a novel approach based on the selective etching along the grating region has been analyzed, leading to high-sensitivity refractive index sensors based on intensity measurements.