We have built a Fizeau fiber interferometer to investigate the internal cylindrical defects in an aluminum plate based on laser ultrasonic techniques. The ultrasound is excited in the plate by a Q-switched Nd:YAG laser. When the ultrasonic waves interact with the internal defects, the transmitted amplitudes of longitudinal and shear waves are different. The experimental results show that the difference in transmission amplitudes can be attributed to the high frequency damping of internal cylinders. When the scanning point is close to the internal defect, the longitudinal waves attenuate significantly in the whole defect area, and their amplitude is always smaller than that of shear waves. By comparing the transmitted amplitudes of longitudinal and shear waves at different scanning points, we can achieve a C scan image of the sample to realize the visual inspection of internal defects. Our system exhibits outstanding performance in detecting internal cylinders, which could be used not only in evaluating structure cracks but also in exploring ultrasonic transmission characteristics.
This article presents a long-period fiber-grating sensor based on a congruent quasi-helical structure (CQH-LPFG) with the two-parameter measurement of both temperature and curvature. The CQH-LPFG sensor was manufactured using a high-frequency CO2 laser, and an innovative quasi-helical structure was introduced into the two-parameter measurement of the temperature and curvature of the optical fiber sensor with excellent results. The experiment and analysis demonstrate that the curvature sensitivities of the three resonance peaks in the 1440 nm to 1540 nm transmission spectrum were 11.88 nm/m−1, 8.05 nm/m−1, and 11.11 nm/m−1, and the curvature varied ranging from 0.156 m−1 to 0.494 m−1. The three resonance peaks showed temperature responsivities of 29.87 pm/°C, 24.65 pm/°C, and 36.85 pm/°C, respectively, and the linear fit was of excellent quality. In the case of measuring both curvature and temperature changes simultaneously, the resonant peak wavelength of the CQH-LPFG sensor was demodulated through matrix analysis, with dip A and dip C providing superior simultaneous measurements. These features make it a promising candidate for applications such as engineering machinery and the health inspection of buildings.
We propose a type of hollow planar waveguide with corrugated walls, which can realize electrically tunable terahertz (THz) filtering by filling the slit with liquid crystals. When the THz signals propagate in a planar waveguide with periodic corrugations, the transmission spectrum always exhibits many pass and stop bands. Inserting a section of defects in the middle of the periodic corrugations can excite an extremely narrow transmission peak, which would be a very good THz filter for frequency division. To achieve tunability of this narrow linewidth THz filter, we also fill the slit between the two corrugated walls with a nematic liquid crystal. The effective refractive index of liquid crystals will change with the external electric field, thus tuning the frequency of the narrow peak. The simulated results show that the center frequency of the proposed filter can be tuned linearly in the frequency range of 0.984~1.023 THz by the external electric field. Moreover, the bandwidth of the filter can be adjusted from 3.2 GHz to 0.3 GHz by increasing the number of periods in the waveguide, and a maximum Q value of 2556 can be achieved when the number of periods at both sides of the defect is 12.