Industrial robots typically perform a variety of tasks and occupy critical positions in modern manufacturing fields. When certain failures occur in the internal structures of robots, it tends to result in significant financial loss and the consumption of human resources. As a result, timely and effective fault diagnosis is critical to ensuring the safe operation of robots. Deep learning-based methods are currently being widely used by researchers to address some shortcomings of traditional methods. However, due to realistic factor limitations, few researchers take the failure pattern of rotating machinery and the location of fault joints into account at the same time, so the fault types of multi-joint robots are not thoroughly investigated. In this case, we proposed a dynamic simulation method that considers the effects of bearing failures at various faulty joint locations and makes it possible to investigate more possible failure cases of multi-joint robots. In addition, we used LSTM and DCNN to perform staged fault diagnosis tasks, allowing us to gradually locate faulty joints and investigate detailed failure forms. According to the experimental results, distinguishable vibration signals corresponding to various fault states are successfully obtained, and our implemented algorithms are validated for their advanced performance in diagnosis tasks via comparative experiments.
The intermittence of the shape detection signal associated with an entire roller-embedded shapemeter roll, used in a seven-pass cold reversible rolling process, is considered. A transient interference at the sensor top surface and the distance between the sensor top surface and the roll outer surface are developed, and a sensor reliability evaluation model is derived. The reliability of the sensor is evaluated via the random perturbation method, and the reliability sensitivity of design variables is proposed. The analysis reveals that the reliability is smallest in the third rolling pass. Of the design variables considered, the initial interference exhibits the largest reliability sensitivity and has the greatest influence on the sensor reliability. A reliability robust design model of the initial interference is therefore developed. A new shapemeter roll is fabricated and tested in a 1050 reversible cold rolling mill. The test results are consistent with the theoretical results, thereby validating the proposed model. The selection of an appropriate initial interference provides an important means of overcoming the adverse effects associated with the thermal deformation of sensor contact surfaces.
1 January 2019 in International Journal of Robotics and Automation
ACTA Press publishes numerous proceedings like technical publications, scientific publications for power and energy systems and research papers for international conferences in the general areas of engineering and computer science.
1 January 2020 in International Journal of Robotics and Automation
Based on the design requirements for prestressed concrete cylinder pipe port-grinding equipment, a self-propelled, a kind of high-efficiency port-grinding robot was innovatively designed. A pre-pressure model of the robot in the non-slip state during the grinding process was developed, and the finite-element simulation analysis of the robot was completed to further verify the reliability of the robot during grinding process. A grinding depth model was established based on Hertz contact and removal profile theory. The relationships between the grinding depth and the grinding motor power, grinding motor rotation speed, rotation speed of the drive motor, and grinding wheel radius were studied, and field grinding tests were performed. The grinding test results showed that grinding depth increases with increasing grinding motor power and decreases with increasing grinding motor speed, driving motor speed, and grinding wheel radius. The test results were used to verify the accuracy of the grinding depth prediction model. Through finite-element simulation analysis of the pipe, the influence of the port-grinding depth on the port strength is further verified. The analysis results lay the foundation for improving the grinding accuracy and grinding depth reliability of a grinding robot.