Javier de Mena Pacheco

Mr. Javier de Mena Pacheco

orcid

Research Focus & Metrics

Academic Career Length

3Years (2024-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
21 March 2025 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Closed access
BCBorja Gutiérrez de Cabiedes
Borja Gutiérrez de Cabiedes
JPJavier de Mena Pacheco
Javier de Mena Pacheco
AHAmadeo de Gracia Herranz
Amadeo de Gracia Herranz
MLMarisa Lopez-Vallejo
Marisa Lopez-Vallejo
Optimizing the power consumption of flip-flops (FFs), as basic building blocks of sequential digital circuits, can substantially reduce the power of the whole system. This work proposes a new Robust Redundant-Free Flip-Flop (RRFF) for ultra-low-power purposes that addresses both aspects that have the potential to reduce power consumption: it has static and contention-free characteristics that provide the robustness required for supply voltage scalability down to the near-threshold region and, at the same time, it eliminates all internal redundant transitions, so that the circuit exclusively consumes dynamic energy when data changes. Measurement results from a test chip fabricated in a 65-nm CMOS technology show that the RRFF achieves 63.4% clock power reduction across a wide voltage range (0.4-1.1 V) and 15.0% power reduction at 100% activity for the same supply voltage range with minimal area overhead compared to the conventional transmission gate flip-flop (TGFF).

31 October 2024 in IEEE Transactions on Circuits and Systems I: Regular Papers
Verified
Journal Article
Open access
JPJavier de Mena Pacheco
Javier de Mena Pacheco
Juan Manuel Carrillo CallejaJuan Manuel Carrillo Calleja
Juan Manuel Carrillo Calleja
TPTomas Palacios
Tomas Palacios
MLMarisa Lopez-Vallejo
Marisa Lopez-Vallejo
Power Management Units (PMU) are present in most electronic devices today. However, for power and area constrained applications, their design becomes a real challenge, especially when cell-sized autonomous microsystems are targeted. This paper presents an LDO regulator and a voltage reference, which are usually a must in any PMU, for autonomous microsystems fabricated in 65 nm CMOS technology. This PMU has been designed to minimize quiescent power and area, consuming a minimum power of 15.6 nW and occupying only 391 $\mu m^2$ , while being able to deliver up to 40 $\mu A$ to the load. No significant degradation was observed, as the measured line regulation is 0.173%/V, the temperature coefficient is 128.4 ppm/ $^\circ$ C over a very wide temperature range going from 0 $^\circ$ C up to 120 $^\circ$ C, and the PSR at low frequencies is $-$ 67.1 dB.

26 September 2024 in Micromachines
Verified
Journal Article
Open access
PDF file
JPJavier de Mena Pacheco
Javier de Mena Pacheco
TPTomas Palacios
Tomas Palacios
MHMarek Hempel
Marek Hempel
MLMarisa Lopez-Vallejo
Marisa Lopez-Vallejo
Voltage-controlled oscillators (VCOs) can be an excellent means of converting a magnitude into a readable value. However, their design becomes a real challenge for power-and-area-constrained applications, especially when a linear response is required. This paper presents a VCO for smart dust systems fabricated by 65 nm technology. It is designed to minimize leakage, limit high peak currents and provide an output whose frequency variation is linear with the input voltage, while allowing rail-to-rail input range swing. The oscillator occupies 592 μm2, operates in a frequency range from 43 to 53 Hz and consumes a maximum average power of 210 pW at a supply voltage of 1 V and 4 pW at 0.3 V. In addition, the proposed VCO exhibits a quasi-linear response of frequency vs. supply voltage and temperature, allowing easy temperature compensation with complementary to absolute temperature (CTAT) voltage.

10 March 2025
Verified
Thesis
Open access
JPJavier de Mena Pacheco
Javier de Mena Pacheco
The concept of smart dust emerged in the early 21st century to enable large-scale distributed sensing and computation. Progress was hindered for years due to the slow development of key technologies like nanotechnology, microelectronics and wireless communication. Recent advancements in technology have continually pushed the limits of what is possible in computing, sensing, and communication, leading to a resurgence of interest in autonomous microsystems. A key frontier in this evolution is the development of cell-sized autonomous microsystems. Achieving microsystems smaller than 100 um has the potential to revolutionize data collection. These tiny devices can be deployed in environments where traditional sensors are either impractical or impossible to use, unlocking numerous groundbreaking applications in fields such as medicine, environmental science, and industrial monitoring to cite a few. In this context, this thesis aims to contribute to the development of cell-sized autonomous microsystems by focusing on the study and design of some necessary circuitry for these systems such as the power management and the communication subsystems. As a consequence, our contributions address the design of these two building blocks while facing the challenges imposed by the drastic miniaturization of these electronic particles. The primary limitation of cell-size microsystems is the extremely constrained space available. This causes a drastic reduction in functionality, which, in some cases such as in this thesis, forces a fully analog circuit design. Another severe limitation lies in the power supply for these microsystems. At such small scales, traditional battery systems are impractical. Therefore, energy-harvesting methods are required, but the amount of energy that can be collected at the cell-size is remarkably small, which raises the difficulty of design. Regarding the energy management of the microsystem, this work describes two power management units (PMUs), each one of them targeting a different scenario. Both PMUs integrate a voltage reference and a voltage regulator with an extremely low area and power consumption. In particular, the first design targets in vitro applications. The temperature stability of this scenario relaxes the constraints related to temperature variations, allowing us to focus more on parameters such as line regulation and power supply rejection. These parameters are crucial to mitigate the fluctuations coming from the power supply. Indeed, our first PMU proposal integrates a voltage reference that features the best line regulation reported in the literature. The second PMU proposal focuses on environments with varying temperatures, requiring temperature compensation. It aims for low supply and temperature dependency while providing sufficient regulated power in a compact area and with minimal quiescent current draw. The existing literature has limited solutions for these challenges. Our second proposal implements a novel topology that incorporates the voltage reference in the feedback loop of the regulator. This optimizes area and power resources and also allows for temperature compensation through transistor sizing. Regarding the communication interface, the analog voltage provided by the sensor of the microsystem must be digitized in order to be transmitted to the outside world. Time-domain digitization emerges as a lightweight digitization method to save significant area and power at the expense of sacrificing some accuracy and speed with respect to traditional ADCs. Consequently, we also present in this thesis a sub-nW voltage-controlled oscillator with a quasi-linear response to perform time-domain digitization. Throughout this dissemination, we address the significant challenges of limited power and area in these designs and show a detailed discussion of the trade-offs involved and the solutions adopted. RESUMEN El concepto de smart dust surgió a principios del siglo XXI para habilitar la detección y computación distribuidas a gran escala. Su desarrollo fue limitado durante años debido a la falta de avances en nanotecnología, microelectrónica y comunicación inalámbrica. Sin embargo, los recientes progresos tecnológicos han renovado el interés en los microsistemas autónomos, destacando los dispositivos del tamaño de una célula, menores a 100 m. Estos sistemas tienen el potencial de revolucionar la recolección de datos en campos como medicina, ciencia ambiental y monitoreo industrial, al operar en entornos donde los sensores tradicionales son imprácticos. Esta tesis contribuye al desarrollo de microsistemas autónomos del tamaño de una célula mediante el diseño de circuitos esenciales, como los subsistemas de gestión de energía y comunicación. Estos diseños enfrentan los desafíos impuestos por la miniaturización extrema, que limita el espacio disponible y reduce la funcionalidad, obligando en muchos casos al uso de circuitos completamente analógicos. Otra las mayores limitaciones de estos microsistemas es el suministro energético. A escalas tan pequeñas, las baterías tradicionales son inviables, lo que hace necesaria la recolección de energía ambiental. Sin embargo, la cantidad de energía recolectable a esta escala es muy limitada, lo que incrementa la complejidad del diseño. Para abordar estos desafíos, este trabajo propone dos unidades de gestión de energía (PMUs), cada una orientada a un escenario específico, integrando una referencia de voltaje y un regulador con un consumo de área y potencia extremadamente bajo. El primer diseño está destinado a aplicaciones in vitro, donde la estabilidad térmica del entorno permite centrarse en parámetros como la regulación de línea y el rechazo al ruido de la fuente de alimentación. Estos...