This article describes the first results obtained from the Surface Waves Investigation and Monitoring (SWIM) instrument carried by the China France Oceanography Satellite (CFOSAT), which was launched on October 29, 2018. SWIM is a Ku-band radar with a near-nadir scanning beam geometry. It was designed to measure the spectral properties of surface ocean waves. First, the good behavior of the instrument is illustrated. It is then shown that the nadir products (significant wave height, normalized radar cross section, and wind speed) exhibit an accuracy similar to standard altimeter missions, thanks to a new retracking algorithm, which compensates a lower sampling rate compared to standard altimetry missions. The off-nadir beam observations are analyzed in detail. The normalized radar cross section varies with incidence and wind speed as expected from previous studies presented in the literature. We illustrate that, in order to retrieve the wave spectra from the radar backscattering fluctuations, it is crucial to apply a speckle correction derived from the observations. Directional spectra of ocean waves and their mean parameters are then compared to wave model data at the global scale and to in situ data from a selection of case studies. The good efficiency of SWIM to provide the spectral properties of ocean waves in the wavelength range [70-500 m] is illustrated. The main limitations are discussed, and the perspectives to improve the data quality are presented.
The surface waves investigation and monitoring (SWIM) instrument onboard the China–France Oceanography Satellite (CFOSAT) can retrieve directional wave spectra with a wavelength range of 70–500 m. This study aims to validate the partitioned integrated wave parameters (PIWPs) from SWIM, including partitioned significant wave height (PSWH), partitioned peak wave period (PPWP), and partitioned peak wave direction (PPWD), against those from National Data Buoy Center (NDBC) buoys. With quasi-simultaneous spectra from two NDBC buoys 13 km away from each other near Hawaii, the methods of comparing PIWPs from two sets of spectra were discussed first. After cross-assigning partitions according to the spectral distance, it is found that wrong cross-assignments lead to many outliers strongly impacting the estimate of error metrics. Three methods, namely comparing only the best-matched partition, changing the threshold of spectral distance during cross-assignment, and maximum likelihood estimation of root-mean-square error (RMSE) of PIWPs, were used to reduce the impact of potential wrong cross-assignments. Using these methods, the SWIM PIWPs were validated against NDBC buoys. The results show that SWIM performs well at finding the spectral peaks of different partitions with the RMSE of PPWPs and PPWDs of 0.9 s and 20°, respectively, which can be a useful complement for other wave observations. However, the accuracy of PSWH from SWIM is not that good at this stage, probably because the high noise level in the spectra impacts the result of the partitioning algorithm. Further improvement is needed to obtain better PSWH information.
7 December 2012 in Journal of Geophysical Research: Oceans
We propose a methodology to extract short‐scale statistical characteristics of the sea surface topography by means of stereo image reconstruction. The possibilities and limitations of the technique are discussed and tested on a data set acquired from an oceanographic platform at the Black Sea. A validation is made with simultaneous in situ measurements as well as results from the literature. We show that one‐ and two‐point properties of the short‐scale roughness can be well estimated without resorting to an interpolation procedure or an underlying surface model. We obtain the first cumulants of the probability distribution of small‐scale elevations and slopes as well as related structure functions. We derive an empirical parametrization for the skewness function that is of primary importance in analytical scattering models from the sea surface.
Over the Philippine Sea, the tropical cyclone (TC) Goni reaches category 5 on 29–31 October 2020. Multi-satellite observations, including CFOSAT SWIM/SCAT and Sentinel-1 SAR data, are jointly analyzed to assess the performances of a parametric model. Recently developed to provide a fast estimation of surface wave developments under rapidly evolving TCs, this full 2D parametric model (KYCM) and its simplified self-similar solutions (TC-wave geophysical model function (TCW GMF)) are thoroughly compared with satellite observations. TCW GMF provides immediate first-guess estimates, at any location in space and time, for the significant wave height, wavelength, and wave direction parameters. Moving cyclones trigger strong asymmetrical wave fields, associated to a resonance between wave group velocity and TC heading velocity. For TC Goni, this effect is well evidenced and captured, leading to extreme waves reaching up to 8 m, further outrunning as swell systems with wavelengths about 200–250 m in the TC heading direction, slightly shifted leftwards. Considering wind field constrained with very highly resolved Sentinel-1 SAR measurements and medium resolution CFOSAT SCAT data, quantitative agreements between satellite measurements and KYCM/TCW GMF results are obtained. Far from the TC inner core (∼10 radii of maximum wind speed), the superposition of outrunning swell systems and local wind waves estimates leads to Hs values very close to altimeter measurements. This case study demonstrates the promising capabilities to combine multi-satellite observations, with analytical self-similar solutions to advance improved understandings of surface wave generation under extreme wind conditions.