1 June 2020 in IEEE Transactions on Geoscience and Remote Sensing
This article describes the first results obtained from the Surface Waves Investigation and Monitoring (SWIM) instrument carried by the China France Oceanography Satellite (CFOSAT), which was launched on October 29, 2018. SWIM is a Ku-band radar with a near-nadir scanning beam geometry. It was designed to measure the spectral properties of surface ocean waves. First, the good behavior of the instrument is illustrated. It is then shown that the nadir products (significant wave height, normalized radar cross section, and wind speed) exhibit an accuracy similar to standard altimeter missions, thanks to a new retracking algorithm, which compensates a lower sampling rate compared to standard altimetry missions. The off-nadir beam observations are analyzed in detail. The normalized radar cross section varies with incidence and wind speed as expected from previous studies presented in the literature. We illustrate that, in order to retrieve the wave spectra from the radar backscattering fluctuations, it is crucial to apply a speckle correction derived from the observations. Directional spectra of ocean waves and their mean parameters are then compared to wave model data at the global scale and to in situ data from a selection of case studies. The good efficiency of SWIM to provide the spectral properties of ocean waves in the wavelength range [70-500 m] is illustrated. The main limitations are discussed, and the perspectives to improve the data quality are presented.
24 March 2021 in IEEE Transactions on Geoscience and Remote Sensing
The accuracy of sea surface parameters retrieved from altimeter missions is predominantly governed by the choice of the so-called “retracking” algorithm, i.e., the model and inversion method implemented to obtain the surface parameters from the backscattered waveform. For continuity reasons, the choice of space agencies is usually to apply the same retracker from one satellite mission to the other to ensure long-time homogeneous series. In this article, taking the opportunity of a new configuration of the nadir pointing measurements onboard the recently launched China France Oceanography Satellite (CFOSAT) with the Surface Waves Investigation and Monitoring (SWIM) instrument (Hauser et al., 2020), the retracking method was upgraded, by implementing a novel algorithm, called “Adaptive” retracker. It combines the improvements brought by Poisson et al., (2018) for the estimation of surface parameters from peaked waveforms over sea ice, improvements in the way the instrumental characteristics are considered in the model (mispointing, point target response) and a more accurate consideration of speckle statistics. In this article, we first show from simulations carried out in the instrumental configuration of SWIM that the Adaptive algorithm has better accuracy and performance than the classical MLE4 algorithm. Then, the geophysical parameters obtained with real data from SWIM are analyzed with comparisons to reference data sets (model and products from altimeters). We show that this new algorithm has several benefits with respect to the classical MLE4 method: no need of lookup tables to correct biases, significant noise reduction on all geophysical variables especially the significant wave height, and performance of inversion over a large set of echo shapes, resulting from standard oceanic scenes as well as highly specular conditions such as over bloom or sea ice.
28 April 2025 in IEEE Transactions on Geoscience and Remote Sensing
The estimation of speckle noise or its suppression is a crucial need to estimate geophysical parameters from radar remote sensing. This is particularly important for the ocean wave spectra retrieval from measured radar backscatter coefficients, as speckle noise can completely dominate the signal in certain conditions. Such measurements are performed by the spaceborne SWIM radar, a near-nadir looking, conical scanning instrument carried by the CFOSAT satellite dedicated to the measurement of directional spectra of ocean waves from the analysis of backscattered fluctuations. In this study, we compare empirical results on the speckle spectrum obtained from the SWIM observations using three different types of acquisition and a theoretical model. We show that a cross-spectral method is efficient for estimating the speckle energy spectrum with a look separation of the order of 13 ms, but shows some limits when this time lag is increased to about 40ms because of the limited footprint overlap. In the case of an azimuthal scanning geometry like SWIM, the speckle energy increases by several order of magnitude in a sector of about ±15° close to the along-track direction. From the theoretical model, we conclude that this is due to the decrease of the Doppler bandwidth in this look geometry and that the variance of the surface scatterer velocities limits the speckle energy increase. It also explains the sensitivity to wind speed of the speckle energy in this azimuthal sector. The almost linear decrease of speckle energy with wavenumber is explained by the spectral response of the radar impulse, slightly modified by range decimation and resampling applied in the first steps of processing. Close to the along-track direction, the variation of speckle energy with latitude is mainly explained by the variation in the integration time imposed by the SWIM on-board command. The model results also show that the impact of Earth rotation on the speckle noise is small. Finally, we show that the speckle correction has an impact on the shape of the wave spectrum derived from the SWIM inversion.