Drought is by far the most important environmental factor contributing to yield losses in crops, including soybeans [Glycine max (L.) Merr.]. To address this problem, a gene that encodes an osmotin-like protein isolated from Solanum nigrum var. americanum (SnOLP) driven by the UBQ3 promoter from Arabidopsis thaliana was transferred into the soybean genome by particle bombardment. Two independently transformed soybean lines expressing SnOLP were produced. Segregation analyses indicated single-locus insertions for both lines. qPCR analysis suggested a single insertion of SnOLP in the genomes of both transgenic lines, but one copy of the hpt gene was inserted in the first line and two in the second line. Transgenic plants exhibited no remarkable phenotypic alterations in the seven analyzed generations. When subjected to water deficit, transgenic plants performed better than the control ones. Leaf physiological measurements revealed that transgenic soybean plants maintained higher leaf water potential at predawn, higher net CO2 assimilation rate, higher stomatal conductance and higher transpiration rate than non-transgenic plants. Grain production and 100-grain weight were affected by water supply. Decrease in grain productivity and 100-grain weight were observed for both transgenic and non-transgenic plants under water deficit; however, it was more pronounced for non-transgenic plants. Moreover, transgenic lines showed significantly higher 100-grain weight than non-transgenic plants under water shortage. This is the first report showing that expression of SnOLP in transgenic soybeans improved physiological responses and yield components of plants when subjected to water deficit, highlighting the potential of this gene for biotechnological applications.
An important area in precision agriculture is related to the efficient use of chemicals applied onto fields. Efforts have been made to diminish their use, aiming at cost reduction and fewer chemical residues in the final agricultural products. The use of unmanned aerial vehicles (UAVs) presents itself as an attractive and cheap alternative for spraying pesticides and fertilizers compared to conventional mass spraying performed by ordinary manned aircraft. Besides being cheaper than manned aircraft, small UAVs are capable of performing fine-grained instead of the mass spraying. Observing this improved method, this paper reports the design of an embedded real-time UAV spraying control system supported by onboard image processing. The proposal uses a normalized difference vegetation index (NDVI) algorithm to detect the exact locations in which the chemicals are needed. Using this information, the automated spraying control system performs punctual applications while the UAV navigates over the crops. The system architecture is designed to run on low-cost hardware, which demands an efficient NDVI algorithm. The experiments were conducted using Raspberry Pi 3 as the embedded hardware. First, experiments in a laboratory were conducted in which the algorithm was proved to be correct and efficient. Then, field tests in real conditions were conducted for validation purposes. These validation tests were performed in an agronomic research station with the Raspberry hardware integrated into a UAV flying over a field of crops. The average CPU usage was about 20% while memory consumption was about 70 MB for high definition images, with 4% CPU usage and 20.3 MB RAM being observed for low-resolution images. The average current measured to execute the proposed algorithm was 0.11 A. The obtained results prove that the proposed solution is efficient in terms of processing and energy consumption when used in embedded hardware and provides measurements which are coherent with the commercial GreenSeeker equipment.
3 July 2022 in International Journal of Remote Sensing
Remote biomass estimation can benefit agricultural practices in several ways, especially larger areas since it does not require local measurements. The advances of the last few decades in machine learning techniques have created new possibilities for estimating aboveground biomass. A pipeline was established from image acquisition to modelling shoot biomass of two wheat cultivars used in Southern Brazil (TBIO Toruk and BRS Parrudo). A UAV was used to acquire multispectral images with high spatial resolution to calculate vegetation indices (VIs). These VIs along with machine learning approaches are used to model the measured biomass of crops in different growth phases. To correlate the wheat images with measured shoot dry biomass, the following regression models were investigated: random forest, support vector regression, and artificial neural networks. An experiment was designed and conducted at the Agriculture Experimental Station of the Federal University of Rio Grande do Sul (EEA/UFRGS) to assess wheat growth. Variability in crop growth was created for all test areas by varying nitrogen availability. To determine shoot biomass, plants were sampled at three different crop growth stages: V6 (stage of six fully developed leaves), three nodes, and flowering. Our results indicate the importance of the radiometric calibration used. Also, the features extracted from images, such as the VIs combined with machine learning models can be used in precision agriculture for predicting the spatial variability of shoot biomass. The best model for Brazilian wheat cultivars was an artificial neural network with of 0.90, RMSE of 0.83t/ha, and nRMSE of 8.95%. We also found a strong correlation between ground NDVI with image-based NDVI, with an of 0.84.
Áreas com diferentes potenciais de rendimento dentro de uma lavoura necessitam ser manejadas separadamente, para fins de aplicação da adubação nitrogenada em cobertura. O equipamento baseado em sensoriamento remoto terrestre (GreenSeeker) é um dos instrumentos utilizados para separar diferentes zonas de manejo. Para fazer isso, o sensor permite a definição de classes para estimar o potencial produtivo de forma ágil, precisa e em tempo real. Com o instrumento, foi desenvolvido um modelo para estimativa do potencial produtivo em trigo e cevada, correlacionando o Índice de Vegetação por Diferença Normalizada (NDVI) com a biomassa seca acumulada na parte aérea, por ocasião da emissão da sexta folha do colmo principal. A base do modelo foi a formação de classes de potencial produtivo correspondentes a zonas específicas de manejo da lavoura. Essas classes não necessitam ser específicas para diferentes cultivares e/ou espécies, visto que não se detectaram diferenças que justificassem a formação de grupos para elas. As superfícies de fundo (resíduos de restevas de soja e milho) tiveram efeitos significativos nas leituras do sensor. O modelo continua válido mesmo se as leituras de NDVI forem feitas antes ou após o período recomendado para tal, podendo ser ajustado com sub ou superestimação. As análises de variabilidade espacial, futuramente, podem avaliar se, as zonas de potencial produtivo estimadas pelas classes de NDVI propostas pelo modelo, correspondem à flutuação espacial da biomassa, doses de N aplicadas e rendimento de grãos. Areas with different yield potential within a field need to be managed separately as for nitrogen application in small grain cereals. Terrestrial remote sensing-based equipment such as the GreenSeeker sensor is one of the tools available to handle different management zones. To do this, the sensor allows the definition of classes to estimate yield potential. A model which correlated the Normalized Difference Vegetation Index (NDVI) to shoot dry biomass at the 6-leaf-stage was developed for estimating yield potential classes for wheat and barley. The model eliminated differences between species and cultivars as no correction for these factors is necessary. The effects of surface background (corn or soybean crop residues) were considered in this model. When readings are carried out before or after the recommended period, the model can be adjusted for under or overestimation. Spatial variability analysis may evaluate if yield potential zones estimated by the NDVI classes proposed in the model are related to spatial variability of shoot biomass, N rates applied and grain yield
Biomass production and nitrogen (N) accumulated in wheat shoots may be used for quantifying optimal topdressing nitrogen doses. The objective of this study was to develop and validate models for estimating the amount of biomass and nitrogen accumulated in shoots and the N topdressing dose of maximum technical efficiency in wheat using the normalized difference vegetation index (NDVI) measured by an active optical canopy sensor. Field experiments were carried out in two years and treatments consisted of N doses applied at plant emergence and as topdressing. NDVI, shoot biomass and N accumulated in shoots at the growth stage of six fully expanded leaves and grain yield were evaluated, being determined the topdressing N dose of maximum technical efficiency (DMTE). The NDVI was positively correlated to shoot biomass and N content in shoots and models for the relationship between these variables were developed and validated. The DMTE was negatively correlated with the NDVI value evaluated at the moment of N topdressing application. Thus, NDVI evaluation by an active optical canopy sensor can be used for nitrogen fertilization in variable rate, allowing the adjustment of applied N doses in different areas within a field.
O nitrogênio tem forte influência no crescimento e desenvolvimento de aveia, nos estádios iniciais. Os afilhos, em especial, a sua produção e sobrevivência, têm relação com o rendimento de grãos e esses aspectos foram avaliados em relação à disponibilidade de N, em cinco experimentos conduzidos na Estação Experimental Agronômica/UFRGS (Eldorado do Sul, RS), no período de 1993 a 1998, com as cultivares UFRGS 10 e UFRGS 15. Os tratamentos consistiram na aplicação de N em: a) diferentes estádios de desenvolvimento (emergência ao emborrachamento) e b) diferentes doses na emergência das plantas. Em todas situações, esses tratamentos foram seguidos ou não pela aplicação de N no final do afilhamento (emissão da 7ª folha do colmo principal). O afilhamento foi estimulado, especialmente, pelo N aplicado no momento da emergência, devido à emissão de maior número de afilhos, e pelo N aplicado na emissão da 7ª folha, que foi importante para reduzir a mortalidade e manter a sincronia de desenvolvimento entre colmo principal e afilhos. Os melhores rendimentos de grãos foram obtidos quando a disponibilidade de N foi elevada no período que engloba as épocas de emergência e final de afilhamento. A aplicação tardia de N (emborrachamento) não resultou em aumento no rendimento de grãos. Na falta de suficiente suprimento de N pelo solo, é necessária a aplicação combinada de nitrogênio na semeadura e por volta da emissão da 7ª folha do colmo principal.