The need to prevent our environment from deterioration caused by toxic waste from drilling mud is a prime objective to the oil and gas industry. The exploration of non-edible plant oil for potential base oil in formulating drilling mud is progressing due to the environmentally friendly nature. This research work involves using a commercial synthetic oil from the oil industry and Hura crepitans oil. This oil samples were used as a base fluid in preparing the mud from which the rheological properties were analyzed. Chemical oil extraction method using soxhlet apparatus was used to extract the oil from H. crepitans seeds; it was then distilled to remove the solvent. The mud samples were formulated with 7 and 9 g concentrations of the viscosifier, and properties were measured at 113 and 158 °F. It was then aged for 16 h at 240 °F, and mud properties were measured before and after hot rolling for comparison. Different rheological models were used to describe the experimental data. The physical properties of the synthetic oil and H. crepitans oil reveal a flash point of 213.8 and 399.2 °F, fire point of 226.4 and 500 °F, viscosity index of 297 and 207, specific gravity/density of 805 and 907, respectively. The mud properties of the synthetic oil-based mud had a better emulsion stability, lower plastic viscosity, higher yield point values, and lower gel strength than the H. crepitans oil-based mud. The rheological properties of synthetic and H. crepitans oil-based mud increase and decrease, respectively, after hot rolling. The optimal concentration of viscosifier was 7 g to have maintained the API acceptable range for the rheological properties. Based on the $$R^{2}$$ values, RMSE values, and the fitted plots, Herschel–Bulkley had a better description of the experimental data.
1 October 2016 in Journal of Petroleum Science and Engineering
This work is aimed at investigating the benefits of replacing conventional process unit operations with process intensified ones in offshore applications. This ensures that better use is made of raw materials, lower energy consumption and a reduced plant volume was achieved. Specifically, a rotating packed bed technology has been used for gas dehydration and sweetening. To achieve the aim of this study, a process intensification approach is used to redesign mature absorption processes to more compact and efficient one. Process simulation using Aspen Hysys was carried out for Triethylene glycol dehydration and monoethanolamine sweetening. More than 36-fold absorption unit size reduction was achieved thereby effecting large decrease in capital and operating costs compared to the conventional packed columns currently utilized in the offshore oil and gas industry. The process intensified technologies therefore can be deployed for offshore applications where space and size considerations are of utmost importance.
The threat of slugging to production facilities has been known since the 70's. This undesirable flow phenomenon continues to attract the attention of researchers and operators alike. The most common method for slug mitigation is by choking the valve at the exit of the riser which unfortunately could negatively affect, production. The focus therefore is to satisfy the need for system stability and to maximize production simultaneously. Active feedback control is a promising way to achieve this. However, due to the complexity of multiphase flow systems, it is a challenge to develop a robust slug control system to achieve the desired performance using existing design tools. In this paper, a new general method for multiphase flow system stability analysis was proposed. Active feedback control was observed to optimize slug attenuation compared with manual choking.